Daily Use - Washing & Drying - Electrolux EW9W161B User Manual

30 www.electrolux.com
• You must drain the water to open the
door:
1. If necessary, touch the Spin button to
decrease the spin speed proposed
by the appliance.
2. Touch the Start/Pause button:
• If you have set
drains the water and spins.
• If you have set
only drains the water.
The option indicator
while the indicator
goes off.
3. When the programme is completed
and the door locked indicator
goes off, you can open the door.
4. Press the On/Off button a few
seconds to deactivate the appliance.
In any case, the appliance
empties the water out
automatically after
approximately 18 hours.
11. DAILY USE - WASHING & DRYING
WARNING!
Refer to Safety chapters.
This appliance is an
automatic washer dryer.
11.1 Complete wash&dry
programmes
Automatic Non-Stop
programme
The appliance is equipped with the
NonStop 3h/3kg programme, an
automatic wash&dry programme where it
is not necessary to set the Dry mode.
To run this programme:
1. After loading laundry and detergent,
press the On/Off button for some
seconds to activate the appliance.
2. Set the NonStop 3h/3kgprogramme
by means of the programme dial.
The indicator
, the appliance
, the appliance
or goes out,
flashes and then
appears on the display
10.16 Stand-by option
The Stand-by function automatically
deactivates the appliance to decrease
the energy consumption when:
• You do not use the appliance for 5
minutes before you touch the Start/
Pause button.
Press the button On/Off to activate
the appliance again.
• After 5 minutes from the end of the
washing programme
Press the On/Off button to activate
the appliance again.
The display shows the end of the last
set programme.
Turn the programme dial to set a new
cycle.
If you set a programme or an
option that ends with water
in the drum, the Stand-by
function doesn't deactivate
the appliance to remind you
to drain the water.
3. Touch the Start/Pause button to start
the programme.
Non-automatic wash&dry
programmes
In some washing programmes, you can
combine Wash and Dry mode for running
a complete wash&dry programme.
Proceed as follows:
1. Press the On/Off button for some
seconds to activate the appliance.
2. Turn the programme dial to the
desired washing programme. The
display shows the default
temperature and spin. If necessary,
change them according to your
laundry. The display also shows the
maximum recommended load for
washing phase.
3. Set the desired options, if there are
available.
4. Touch the Mode button once to
activate also the drying function. The