QSI Quantum Revolution-A User's Operation Manual page 15

Thanks to it's 8 sound channels, the Quantum Revolution allows for an extensive amount of user control over
individual sound volumes. The CVs to change these individual volumes are listed in the chart below:
Changing Individual Sound Volumes (CV 52.X )
X' refers to the value in column 1 of the table, the Primary Index number that will be entered into CV 49.
To change the volume of individual sounds listed in the table below do the following:
Set CV 49 to the Primary Index for the individual sound from the table below.
Enter Volume level in CV 52 as follows: "0" = No sound, "1 – 15" sets volume from the lowest level at "1" to
the highest at "15", with volume levels at 2db increments. Defaults are typically set to 11.
Primary Index
Entered into CV49
13*
15*
26**
*= Turbine Models Only
**= Non-Turbo Charged Models Only
3C: Individual Sound Volume
CV
0 52
8 52.8
10 52.1
52.13
14 52.14
52.15
16 52.16
19 52.19
21 52.21
22 52.22
24 52.24
52.26
28 52.28
34 52.34
37 52.37
40 52.40
46 52.46
Range Individual Sound
0-15
0-15
0-15 Diesel Motor
0-15 Turbine Whoosh Vol
0-15 Turbo Charger Vol.
0-15 Turbine Whine Vol.
0-15
0-15 Vents and Cooling Fans
0-15 Long Air Let-off
0-15 Short Air Let-off
0-15 Squealing Brakes/Flanges
0-15 Generator
0-15 Dynamic Brakes
0-15 Coupler Sounds
0-15 Air Brake Sounds
0-15 Alternate Horn Vol.
0-15 User Added Sound Effects
Vol.
Horn
Bell
Air Pump
15