Specifications; Operation; Starting The Hedge Trimmer - Toro Flex-Force Power System 51841 Operator's Manual

Specifications

Model 51841
Cutting 610 mm (24 inches)
Length
Rated
60V DC maximum, 54 VDC nominal usage
Voltage
No-load 3200 spm at 60 VDC max
Speed
Cutting 19 mm (3/4 inch)
width
Charger 88602 or 88610 (included with 51841)
Type
Battery Type 88620 (included with 51841), 88625, 88640,
88660, or 88675
Appropriate Temperature Ranges
Charge/store the battery pack
at
Use the battery pack at
Use the machine at
*Charging time will increase if you do not charge the
battery pack within this range.
Store the machine, battery pack, and battery charger
in an enclosed clean, dry area.
5°C (41°F) to 40°C (104°F)*
-30°C (-22°F) to 49°C (120°F)*
0°C (32°F) to 49°C (120°F)*

Operation

Starting the Hedge Trimmer

1. Remove the protective cover from the blades
(Figure 4).
WARNING
The hedge trimmer blades can cause
cuts or amputation.
Be careful when handling the hedge
trimmer with the protective cover
removed.
1. Protective cover
2. Make sure that the vents on the hedge trimmer
are clear of any dust and debris.
3. Align the cavity of the battery pack with the
tongue in the handle housing, grasp the handle,
and push the battery pack into the handle until
the latch locks into place
1. Auxiliary-handle switch
2. Auxiliary handle
3. Lock switch
4. Place 1 hand on the trigger handle. Place the
other hand on the auxiliary handle
9
Figure 4
2. Blades
(Figure 5).
Figure 5
4. Trigger
5. Battery latch
6. Hedge trimmer venting
areas
(Figure
g308414
g308413
5).