Buick 2004 Park Avenue Owner's Manual page 110

Keep the original transmitter for use in other vehicles as
well as for future HomeLink
recommended that upon the sale of the vehicle, the
®
programmed HomeLink
security purposes. Refer to "Erasing HomeLink
or, for assistance, contact HomeLink
www.homelink.com or by calling 1-800-355-3515.
Be sure that people and objects are clear of the
garage door or gate operator you are programming.
When programming a garage door, it is advised to
park outside of the garage.
It is recommended that a new battery be installed in
your hand-held transmitter for quicker and more
accurate transmission of the radio frequency.
Your vehicle's engine should be turned off while
programming the transmitter. Follow these steps to
program up to three channels:
1. Press and hold down the two outside buttons,
releasing only when the indicator light begins to
flash, after 20 seconds. Do not hold down the
buttons for longer than 30 seconds and do not
repeat this step to program a second and/or third
transmitter to the remaining two HomeLink
2. Position the end of your hand-held transmitter about
1 to 3 inches (3 to 8 cm) away from the HomeLink
buttons while keeping the indicator light in view.
2-44
®
programming. It is also
buttons should be erased for
®
Buttons"
®
on the internet at:
®
buttons.
3. Simultaneously press and hold both the desired
button on HomeLink
button. Do not release the buttons until Step 4
has been completed.
Some entry gates and garage door openers may
require you to substitute Step 3 with the procedure
noted in "Gate Operator and Canadian
Programming" later in this section.
4. The indicator light will flash slowly at first and then
rapidly after HomeLink
frequency signal from the hand-held transmitter.
Release both buttons.
5. Press and hold the newly-trained HomeLink
and observe the indicator light.
If the indicator light stays on constantly, programming
is complete and your device should activate when the
®
HomeLink button is pressed and released.
To program the remaining two HomeLink
begin with Step 2 under "Programming HomeLink
Do not repeat Step 1 as this will erase all of the
programmed channels.
If the indicator light blinks rapidly for two seconds
and then turns to a constant light, continue with
Steps 6 through 8 following to complete the
® programming of a rolling-code equipped device
(most commonly, a garage door opener).
®
and the hand-held transmitter
®
successfully receives the
®
®
buttons,
button
®
."