Canon NP6512 Service Manual page 69

4. Clearing the Error Code from Memory
If 'E000', 'E001', 'E002', or 'E003' is indicated, remove the cause of the error, and clear the
memory.
1) Turn on the power while shorting JP103 and JP104 on the DC controller PCB with a screw-
driver.
• The display will indicate 'F'.
2) Turn off and then on the power switch to check the copying operation.
Caution:
When a fault associated with 'E000', 'E001', 'E002', or 'E003' is detected, the power will auto-
matically turn off. It will still turn off even when turned on without removing the fault.
To find out which code turned off the power, disconnect J207 from the composite power
supply PCB, and turn on the power.
Figure 4-4 shows the label attached behind the front upper cover. At the factory, each indi-
vidual machine is adjusted, and its adjustment values are recorded on the label.
If you have entered any new value in the field, be sure to record it on the label. If you have
replaced the DC controller PCB, be sure to enter the values recorded on the label in service
mode.
If you have replaced the drum unit, composite power supply PCB, or pre-exposure PCB, on
the other hand, be sure to enter the values recorded on the label of the appropriate part. Then,
record these values on the service label.
SERVICE
JP103
Figure 4-3
30 REGIST
31 LE_BLANK
32 PRIMARY
33 IP_OFST
34 PW_OFST
35 IP_ADJ
36 LENS_ADJ
37 PREX_LP
38 LAMP_ADJ
Figure 4-4
CHAPTER 4 SERVICE MODE
JP104
FB5-2777
4-3