Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Bunn Manuals
  4. Water Dispenser
  5. dispenser
  6. Installation and operating manual

Bunn dispenser Installation And Operating Manual

Bunn dispenser manual
Hide thumbs
1
2
3
4
5
6
7

Advertisement

Quick Links

Download this manual
POWDER
AUTO FILL
For ULTRA-2
INSTALLATION & OPERATING GUIDE
BUNN-O-MATIC CORPORATION
POST OFFICE BOX 3227
SPRINGFIELD, ILLINOIS 62708-3227
PHONE: (217) 529-6601
FAX: (217) 529-6644
To ensure you have the latest revision of the Operating Manual, or to view the Illustrated Parts
Catalog, Programming Manual, or Service Manual, please visit the Bunn-O-Matic website, at
www.bunn.com. This is absolutely FREE, and the quickest way to obtain the latest catalog and
manual updates. For Technical Service, contact Bunn-O-Matic Corporation at 1-800-286-6070.
29793.0001G 08/11 ©2002 Bunn-O-Matic Corporation

Advertisement

loading

Related Manuals for Bunn dispenser

Summary of Contents for Bunn dispenser

  • Page 1 To ensure you have the latest revision of the Operating Manual, or to view the Illustrated Parts Catalog, Programming Manual, or Service Manual, please visit the Bunn-O-Matic website, at www.bunn.com. This is absolutely FREE, and the quickest way to obtain the latest catalog and manual updates. For Technical Service, contact Bunn-O-Matic Corporation at 1-800-286-6070.
  • Page 2 SOLE OPTION AS SPECIFIED HEREIN, TO REPAIR, REPLACEMENT OR REFUND. In no event shall BUNN be liable for any other damage or loss, including, but not limited to, lost profits, lost sales, loss of use of equipment, claims of Buyer’s customers, cost of capital, cost of down time, cost of substitute equipment, facilities or services, or any other special, incidental or consequential damages.

  • Page 3: Initial Setup

    This equipment supplies a liquid mix to the hoppers on the ULTRA-2 dispenser. It is for indoor use only on a sturdy counter or shelf. Loosen auger motor cover screws. Remove rear plastic plug from trim strip between hopper drip trays.
  • Page 4 1. On the Ultra touch pad, make the following set- tings: a) POWER- “ON” b) DAY/NIGHT- “DAY” 2. Pull the Powder Auto-Fill fully forward on its sup- port rails and open the door. 3. Fill the Powder Auto-Fill product hopper as fol- lows: a) Pull the slide gate closed on the Powder Auto-Fill product hopper elbow and remove the hopper from...
  • Page 5 ULTRA auger motor cover. c) Attach a flexible water line to the .25” flare fitting on the back panel of the Powder Auto-Fill. NOTE: A water strainer assembly (BUNN-O-MATIC #23820.1000) should be installed in line prior to the flexible water line.
  • Page 6 RECOMMENDED DAILY CLEANING AND MAINTENANCE TIPS This should be done in conjunction with the recommended weekly cleaning of your ULTRA-2 machine. Removing and cleaning the whipper chamber (once a day): 1. Open the cabinet door. 2. Pull the mixing chamber out of the whipper cham- ber.

  • Page 7: Fault List

    Door Lamp Flashes ON/OFF at 50% duty cycle Two flashes about every 2 seconds Three flashes about every 2 seconds Four flashes about every 2 seconds DELAYED AUTOFILL CIRCUIT BOARD ADJUSTMENT 1. Unplug PAF unit from power source. 2. Remove rear panel. 3.