Electrolux EHL40X User Manual page 105

Hide thumbs Also See for EHL40X:
Table of Contents

Advertisement

Available languages

Available languages

1
The little bars show the progress of the washing programme.
2
Messages show in this part of the display.
3
Symbols
DELAY START - symbol flashes when countdown is in progress.
MULTITAB - comes on when the option is active.
SOUND VOLUME - comes on when the audible signals are deactivated.
First use
Before using your dishwasher for the first
time:
• Ensure that the electrical and water con-
nections comply with the installation in-
structions
• Remove all packaging from inside the ap-
pliance
• Set the water softener level
Setting the water softener
The dishwasher is equipped with a water
softener designed to remove minerals and
salts from the water supply, which would
have a detrimental or adverse effect on the
operation of the appliance.
The higher the content of these minerals and
salts, the harder your water is. Water hard-
ness is measured in equivalent scales, Ger-
man degrees (dH°), French degrees (°TH)
and mmol/l (millimol per litre - international
unit for the hardness of water).
The softener should be adjusted according
to the hardness of the water in your area.
Your local Water Authority can advise you on
the hardness of the water in your area.
The water softener must be set in two
ways: manually, using the water hard-
ness dial and electronically.
Setting manually
The dishwasher is factory set at position
2.
1. Open the dishwasher door.
Water hardness
°dH
51 - 70
91 - 125
43 - 50
°TH
mmol/l
9,1 - 12,5
76 - 90
7,6 - 9,0
Symbols
• Pour 1 litre of water into the salt container
and then fill with dishwasher salt
• Fill the rinse aid dispenser
If you want to use combi detergent
tablets such as: '3 in 1', '4 in 1', '5 in
1' etc. set the multitab function. (Re-
fer to 'Multitab function').
2. Remove the lower basket from the dish-
washer.
3. Turn the water hardness dial to position
1 or 2 (see chart).
4. Replace the lower basket.
Setting electronically
The dishwasher is factory set at level 5.
Enter Menu options - WATER HARD-
NESS .
Use the option button to set the level of the
water softener, according to the hardness of
the water. (Refer to the table).
Adjusting the water hardness setting
manually
2
2
electrolux 73
Use of
electronically
level 10
level 9
salt
yes
yes

Advertisement

Table of Contents
loading

Table of Contents