Screen Menu - Sony VPL-VW90ES Operating Instructions Manual

Screen Menu

The Screen menu is used to adjust the input signal. You can adjust the size of the picture,
and select wide screen mode, etc.
.
Note
These items may not be available, depending on the type of input signal. For details, see "Input
Signals and Adjustable/Setting Items" (1 pages 89 to 92).
Wide Mode
(Video signal)
You can set the aspect ratio of the picture to be displayed for the
current input signal. (1 page 35) This item is enabled only when a
video signal (preset memory numbers 1 to 14) (1 pages 86, 86) is
input.
Wide Zoom: A 4:3 aspect ratio picture is enlarged naturally to fill the
screen. The upper and lower portions of the screen are slightly cut off.
Normal: A 4:3 aspect ratio picture is displayed in the center of the
screen and enlarged to fill the screen vertically.
Full: A picture squeezed to 4:3 aspect ratio is displayed in its original
aspect ratio. When a 4:3 aspect ratio picture is displayed, the picture is
enlarged horizontally to fill the 16:9 screen.
Zoom: A picture is enlarged vertically and horizontally in the same ratio
to fill the screen. The upper and lower portions are cropped.
Anamorphic Zoom: A 2.35:1 aspect ratio picture is converted to a
normal 16:9 picture on the screen. This mode is best suited when
using a commercially available Anamorphic lens which converts a
normal 16:9 aspect ratio picture to a 2.35:1 picture (1 pages 8, 36).
If you set "Trigger Select" on the Installation
"Anamorphic Zoom," 12 V signals will be output from the TRIGGER
connector (1 page 64).
You can switch settings by pressing WIDE MODE on the remote
control.
menu to
57