Advertisement
3. PERFORM ONE-TIME CALIBRATION RIDE
1) If you haven't done so already, perform the Fast Start sequence prior to doing the Cal Ride.
2) Wear your usual biking clothes and remain in your normal ride position for the entire Cal Ride.
3) Place iBike on mount. Ride to the place where you'll do your Cal Ride; the iBike will
automatically detect the wireless sensors.
4) Press-hold the top arrow to enter setup. Click the up arrow twice to select "CAL RIDE".
Click the center button to begin the Cal Ride steps.
5) If you performed Tilt and Cal Wind steps more than 30 minutes before starting the Cal Ride,
you must perform the Tilt and Cal Wind steps again; the iBike automatically guides you through
these two calibrations.
6) When your iBike is ready for the Cal Ride the word "Start" will flash. Click the center button.
7) The top window shows speed, middle window shows distance, bottom window says "Out".
8) Ride out for one mile at a leisurely pace. The center window shows the distance traveled.
It's OK to stop during the Cal Ride but it's best do the Cal Ride in light traffic and light winds.
o
9) Once you have traveled a little over 1 mile, the iBike flashes "go bac, turn 180
". SLOW
DOWN, STOP, and turn around safely. The iBike says "BAC" without flashing. Ride back to
your starting point on the same route. As you ride back the center window will count down until
zero distance is remaining. At the end of your iBike will return to "CAL RIDE". Press-hold the
up arrow to exit Setup.
NOTE: IT'S OK TO RIDE MORE THAN ONE MILE BEFORE TURING AROUND. THE "GO BAC,
SLOW DOWN" MESSAGE WILL FLASH CONTINUOUSLY UNTIL YOU SLOW TO LESS THAN
10 MPH. IF YOU RIDE MORE THAN ONE MILE BEFORE TURNING THE ACCURACY OF YOUR
CAL RIDE WILL IMPROVE.
Your iBike is now ready to ride. Consult the "iBike Detailed Instructions" on the many features
of your new iBike, as well as "USER" and "RACR" sequences that can fine-tune your iBike's
performance even more.
"USER", "RACR" SEQUENCES, AND DAY-TO-DAY SETUP SCREENS
In addition to "FAST START", your iBike also has "USER" and "RACR" (racer) sequences.
The USER sequence includes date, time, absolute wind, and display settings, as well as coast
down, fitness test, and indoor trainer settings. Performing the USER sequence is optional but
recommended.
The RACR sequence includes ESTIMATE CRR, TSS/IF/NP display, FTP configuration, CDA
display, (iAero only) and TOTAL HOURS and DISTANCE log. Performing the RACR sequence
is optional.
For your daily riding, in setup you can conveniently and immediately access CAL WIND, TILT,
CAL RIDE, BATT VOLTAGE, ALTITUDE, TOTAL WEIGHT, SCAN (WIRELESS SCAN),
SET PROFILE, RECORD INTERVAL, ERASE DATA, AND FIRMWARE VERSION
SCREENS.
4
Advertisement
