Advertisement
2. PERFORM "FAST START" SETUP SEQUENCE
1) Use a bathroom scale to measure the total weight of you, your bike, and bike equipment (water
and shoes).
2) Determine front wheel tire circumference (default is 700x 23c wheel, 2096mm). See detailed
instructions for other wheel sizes, or email us at
technicalsupport@velocomp.com
3) Enter "Set Up" by press-holding iBike's UP arrow for two seconds (UP arrow for set-UP).
4) You should see the screen "Yes Fast Start". If you don't see this screen, detach the iBike
from its mount, remove the iBike's battery, insert battery backwards momentarily, then reinsert
battery normally and replace battery cover. Place iBike on mount and enter Setup.
5) "Yes Fast Start" screen appears. To begin Fast Start sequence, click the up arrow.
NOTE: IF YOU SEE THE SCREEN "REL 4xy" (xy are numbers, 24 or higher) CLICK THE
UP ARROW ONCE TO RETURN TO "YES FAST START". THEN, CLICK THE UP
ARROW AGAIN TO ENTER THE FAST START SEQUENCE.
6) The "UNITS" screen appears. To select English or metric units, click the center button. The
units screen will flash. Click the up arrow to select metric units (km/h will flash in the top
window). Click the up arrow again to select English units. When the screen flashes your desired
choice, click the center button. The message "done" flashes, indicating that your choice has been
memorized. The screen advances to "TIRE CIRC".
7) "TIRE CIRC" (tire circumference) is pre-set to 2096mm (700 x 23C wheel). Click the center
button to check and enter the correct tire circumference. If needed, enter the circumference of
your tire in mm, using the left/right arrows to select the flashing digit to change, and the up/down
arrows to change the value of the digit. Click the center button. The screen flashes "done" and
advances to the next step, "TOT WGHT".
8) Enter the total weight of you, your bike, and your equipment. Click the center button and use
the up/down and left/right arrows to enter your correct total weight. Click the center button to
accept. The screen flashes "done" and advances to "EST AERO".
9) To start the "EST AERO" (Estimate aerodynamic drag) steps, click the center button. Enter
your height (in inches or cm, depending on Units choice), then click the center button. Next,
enter your body weight. Next, select your NORMAL riding position, the position you ride in
most often. Choose between Hoods, Drops, and TT. The first choice is "Hoods". The word
"No" flashes. If you normally ride on the hoods, select "Yes" with the up arrow, then click the
center button. If you do NOT normally ride on the hoods, then click the center button to select
"Hoods No". You will see "Drop No"; select your choice with the up/down arrow, then click
the center button to accept. The final choice is "TT" (time trial); select Yes/No. As soon as you
select "Yes" for one of the three choices, your aerodynamic drag is estimated automatically for
the ride position chosen, "done" will flash, and the screen advances to the "TILT" calibration.
NOTE: "FAST START" ACCURATELY ESTIMATES YOUR DRAG COEFFICIENTS. SEE
OWNER'S MANUAL FOR COAST DOWN CALIBRATION THAT MEASURES DRAG
COEFFICIENTS.
2
Advertisement
