Electrical Installation - Beko BWI45S1D-242 User Manual

7

Electrical Installation

WARNING !
7.1 This appliance must be earthed.
Improper grounding could cause electrical shock.
7.2 Remember to SWITCH OFF the mains before
carrying out any electrical work.
7.3 Refer to TABLE 1 for the correct cable size.
7.4 Use double insulated cable of over 2.5mm².
7.5 Lead the power cable from MCB to a "ON/OFF"
double pole Linked Switch having a contact
separation of at least 3mm in all poles outside the
bathroom, then lead a cable to the terminal block
inside the Heater Unit. (Fig. 4)
(MCB )
ON/OFF Double Pole Switch
Note :
Refer to TABLE 1 for electrical
loading and correct size of
wire conductor.
Fig. 4
PROCEDURE :
7.6 Insert the wall embedded cable through Side
Entry 'A' by cutting a hole at the source cord rubber
holder and lead the cable to Cable Bracket 'B'. (Fig. 6)
10 / EN
METHOD OF ALIGNMENT WHEN REPLACING FRONT COVER
7.7 Connect the cable as following
BROWN or RED
BLUE or BLACK
GREEN or GREEN/YELLOW
7.8 Clamp the cable to the correct position.
CHECK IF THE WIRING CONNECTION IS
CORRECT and replace the cover.
7.9 When putting back the Front Cover, Please
take note of the procedure shown below:
- Ensure the position is correct, turn the
emperature COntrol Knob Insert to OFF
position as shown in FIg.A (At the Heater Base)
- Install the Front Cover, turn the Temperature
Control Knob to OFF position to align with the
VR shaft as shown in FIg.B (At the Front Cover)
7.10 Fix the Temperature Control Knob and
screw 'A' (Fig. 2),
7.11 Insert the pump knob as shown in FIg. A.
A
B
Fig. 6
- LIVE (L)
- NEUTRAL (N)
- EARTH ( )