Safety Information - Beko BWI45S1D-242 User Manual

2

Safety Information

WARNING !
2.1
Products manufactured by Beko are safe provided
they are installed, used and maintained in good working
order in accordance with our instruction and
recommensations. Always refer to this manual if you have
any doubt.
2.2 The appliance must be earthed. Improper grounding
could cause electrical shock.
2.3 If any of the following conditions occur as shown
below, immediately switch off the mains and contact the
Beko Call Center. Never attempt to repair the unit yourself:
• If the Heater begins to make and odd noise, smell
or smoke.
• If ELCB trips and Heater Indicator does not light up.
• Water temperature cannot be controlled.
• If the Heater shows signs of a distinct change in
performance.
• If water leaks from inside
2.4 For Pump Model, it is highly recommended to connect
the Water Inlet Connection to tank storage supply, otherwise
it may cause damage to the Pump Motor.
2.5 When the Shower is used by someone such as child,
elderly persion, sick person and physically handicapped
person, the person concerned is kindly requested to pay
attention and check the shower temperature by hand from
time to time. User is advised to test and adjust the water
temperature before using
2.6 During lightning/thunder, switch off the electrical supply
to the shower unit in advance to protect the shower unit
against possible damage.
2.7 The earth continuity conductor of the electrical
installation must be effectively connected to all exposed
metal parts of the other appliances ans services in the room,
which in the heater is to be installed to conform to local
regulations and ensure proper earthing/grounding for ELCB
to be effective.
2.8 WARNING : Metallic/chromed and conductive
control valve shall not be used.
NOTE: When removing the unit from the package, a smal
amount of water may be found inside. This is normal as the
unit is tested during manufacturing process.
CAUTION !
2.9 Installation must be carried out by a qualified
personnel and in compliance local authority regulations.
2.10 This Heater must be permanently connected to the
direct main supply. A plug and socket is not recommended
to be used.
2.11 For the correct size of wire conductor corresponding
to different electrical loadings, please refer to Table 1.
2.12
The Heater operates at a minimum water flow rate
of 2.0litre/min and maximum working pressure of 6 bars.
for direct connection from the water tank, the Heater must
have an installation minimum 1.0m below the water tank.
2.13 The Heater will not function if there is insufficient
water flow (min 2.0litre/min) to trigger the flow switch.
2.14 The built-in-ELCB will automatically cut off the
power supply in case there is a current leakage from 15mA.
2.15 The thermostat will automatically cut off the water
supply if it has sensed an abnormal rise in water
temperature.
5 / EN