Replacing Battery - BMW 2008 5 Series Owner's Manual

Malfunction
The comfort access function may malfunction
due to local radio waves. Then open or close the
vehicle with the buttons on the remote control
or with a key. To start the engine following this,
insert the remote control in the ignition lock.
When unlocking or locking/comfort closing do
not simultaneously grasp the door handle and
touch the surfaces, arrow 2 or 3. Otherwise, you
may limit the function.

Replacing battery

If the battery of the remote control is dead, a
message will appear in the Control Display.
1. Remove integrated key from remote con-
trol, refer to page 28.
2. Remove cover.
3. Lay in new battery with positive side facing
upward.
4. Press cover closed.
Return used battery to a recycling collec-
tion point or to your BMW
40
Online Edition for Part no. 01 41 0 014 240 - © 08/07 BMW AG
Windows
your field of vision until they are shut.
Always take along the remote control when you
leave the vehicle, otherwise children could, for
example, operate the windows and injure them-
selves.<
Opening, closing
> Press switch to resistance point:
The window continues to open as long as
you keep the switch pressed.
>
Press switch beyond resistance point:
The window opens automatically. Pressing
the switch again stops the opening move-
ment.
You can close the windows in the same manner
by pulling the switch.
Separate switches for the rear windows are
located in the rear.
For information on using the convenient opera-
center.<
tion at the door lock or with the remote control,
refer to page
For information on comfort closing with comfort
access, refer to page 39.
After switching off ignition
You can still operate the windows with the
remote control removed or the ignition
switched off for approx. 1 minute, as long as
neither of the front doors has been opened.
To prevent injuries, exercise care when
closing the windows and keep them in
30 or 32.