Components; Control Panel Components - Westinghouse WGen5300DFv User Manual

COMPONENTS

CONTROL PANEL COMPONENTS

1
1. Fuel Selector Switch: Used to select gas or propane
operation.
2. Run/Stop Switch: Push to Run position to start or
Stop position to shut the generator off.
3. Voltage Selector Switch: Select 120V or 240V. Turn
generator OFF before switching voltage. When
operating at 240V only the L14-30R receptacle is
operational.
4. Data Center: Toggle to show voltage, frequency,
total hour meter, and run/maintenance timer.
5. 120/240 Volt AC, 30 Amp NEMA L14-30R Twist
Lock Receptacle: Receptacle can supply either
120V or 240V output.
6. 120 Volt AC, 30 Amp NEMA TT-30R Receptacle:
Receptacle can supply a maximum of 30 Amps.
DATA CENTER
Voltage:
Displays current voltage
output.
METER V-F-T
Mode Button
2 3
11
Frequency (Hz):
Displays power output
frequency in Hertz.
Push the Mode button to cycle through
the data display modes.
COMPONENTS
4 5
10
7. 120 Volt AC, 20 Amp Duplex NEMA 5-20R
Receptacles: Receptacles can supply a maximum of
20 Amps.
8. 20 Amp AC Circuit Breaker: Circuit breaker limits
the current that can be delivered through the NEMA
5-20R receptacles to 20 Amps.
9. 30 Amp AC Circuit Breaker: Circuit breaker limits
the current that can be delivered through the TT-
30R receptacle to 30 Amps.
10. 22-Amp Circuit Breakers: Each circuit breaker
limits the current that can be delivered through
each 120 Volt leg on L14-30R to 22amps.
11. Ground Terminal: The ground terminal is used to
externally ground the generator.
Lifetime Hours:
Displays the lifetime run
hours.
Westinghouse Outdoor Power Equipment, LLC | 9
7 7
6
8
9
Run Time/Maintenance:
Displays current run time.
Resets to zero when shut
down. Maintenance
reminder displayed
when required.
Maintenance Codes:
P25: Change engine oil
P50: Clean air filter,
Change engine oil
P100: Change engine oil,
clean air filter, replace
fuel filter