Exchanging The Hard Disk Of The Vsb 40.1, Nn Variant - Bosch Rexroth IndraControl VSB 40.1 Project Planning Manual

62/83 Bosch Rexroth AG
Maintenance and Installation
8.4.2

Exchanging the Hard Disk of the VSB 40.1, NN Variant

NOTICE
Backup the hard disk regularly.
The hard disk to be inserted must already have an installed oper‐
ating system, if no external boot medium is connected to the control
cabinet PC. In any case, it is recommended to have a completely
installed operating system on the hard disk to shorten the installa‐
tion time!
The change of the hard disk for the two variants of the VSB 40.1 is not identic
because the hard disk is located at different positions.
1. Store all required user data as well as the operating system settings of the
system either on an external storage medium or via the network connec‐
tion!
2. Shut down the operating system.
3. Wait until the power supply unit switches off and then, switch off the supply
voltage. If required, unplug all connectors.
4. Put the VSB 40.1 on a solid mat, so that the connector panel looks in your
direction.
5. Loosen the four screws with which the mounting frame is fixed at the VSB
40.1:
Fig.8-5: Loosen the fastening screws at the mounting frame
6. Remove the VSB 40.1 from the mounting plate (mounting frame) and en‐
sure that the connector panel is turned away from you when putting the
VSB 40.1.
7. Loosen the fastening screws of the hard disk frame. The hard disk and
(depending on the device design) the CD/DVD drive are mounted on this
plate:
DOK-SUPPL*-VSB*40.1***-PR03-EN-P
Rexroth IndraControl VSB 40.1 Control Cabinet PC
Data loss and reinstallation of the operating
system and application programs after a hard
disk exchange due to missing or irregular back‐
up of the hard disk.