Installation Table Assembly; Inset Shelf - OAKWORKS MEDICAL PRODUCTS Powerline Series User Manual

Treatment tables
Table of Contents

Advertisement

INSTALLATION
T A B L E A S S E M B L Y
TOOLS REQUIRED:
9/16" / 14mm Wrench/Socket
SUPPLIED PARTS:
TOOLS
1 - Large Allen Wrench
1 - Small Allen Wrench
The tables are shipped complete in one box. Follow the step
below to fully assemble the table:
1.
Remove the table from the box and place it down on the floor with the
top down. Remove all hardware and the Leg Brace.
2.
Unfold the legs to a vertical position and remove any protective wrappings.
3.
Install the long large bolts, reinforcement plates, spring washers and lock
nuts as shown, two bolts on each leg. Using the large Allen wrench and
9/16" / 14mm wrench socket, tighten all 8 bolt/nut connections to 12 ft-lbs
minimum or until the spring washers are flat.
4.
Install the barrel nut into the leg brace being sure the screw slit is horizon-
tal. Install the short bolt through the leg rail. Start the bolt into the barrel nut
using your fingers first. After the bolt has started, tighten the bolt using the
small Allen wrench. Make sure the leg brace is flush with the adjoining
rails while tightening bolts. Repeat on opposite end of the leg brace.
5.
Turn your table right side up. Get up on the table and rock back and forth
to check that all bolts are tight. The table should be very stiff. Dependent
on the environmental conditions of your table, it may be necessary to
periodically re-tighten the hardware.
S H E L F A T T A C H M E N T
If you have ordered a shelf, drop the shelf into place. The shelf has grooves at both ends that enable
it to be held firmly in place by the legs. If necessary, the shelf can be further stabilized by installing the
enclosed Velcro™ strips. Place strips on each corner of the shelf's bottom side, and on each end of the
rails. Make sure not to mismatch Velcro™ strips; place all "hook" or all "loop" pieces on either the rail or
shelf. The shelf is reversible and can be used on either side.
LEG HARDWARE
8 -Reinforcement Plates
16 - Spring Washers
4 - Long Large Bolts
4 - Lock Nuts
LEG BRACE
1 - Wood Leg Brace
2 - Short Bolts
2 - Barrel Nuts
Leg Brace
Barrel Nut
Short Bolt
6

Advertisement

Table of Contents
loading

Table of Contents