Table of Contents
Advertisement
Main Menu
Compass Calibration
If you see ''
−−
'' in the compass
display, the compass is self-
calibrating. The compass may need
to be manually calibrated after
exposure to a strong magnetic field.
If the compass seems to be
continuously showing the wrong
direction and is not self-calibrating,
do the following.
Do this procedure in an open
NOTE:
area, away from buildings, power
lines, and other vehicles.
1.
Press and hold the
buttons simultaneously until
the temperature display changes
(about 5 seconds).
2.
Verify that the zone setting is
correct by finding your area on the
map on page
232
.
Table Of Contents
3.
Press the
count down, or the
and
count up. Once the correct zone is
displayed, continue to step 4.
4.
Press the OFF button to save the
zone selection.
5.
Press the OFF button again to
begin calibrating the compass.
The heading should now show
''
''.
−−
button to cycle the
button to
2008 TL
Compass
6.
Drive the vehicle slowly in two
complete circles.
7.
When the display goes from
''
'' to an actual heading, the
−−
unit is calibrated and the display
returns to normal.
CONTINUED
231
Advertisement
Chapters
Table of Contents
