Climate Control - Acura 2008 TL Owner's Manual

Main Menu
To Remove Exterior Frost or Ice
From the Windows
1. Select . The system
automatically switches to fresh air
mode and turns on the A/C. The
A/C indicator does not come on if
it was previously off.
2. Select .
3. Set the fan and temperature
controls to maximum level.
To clear the windshield faster, you
can close the dashboard corner vents
by rotating the wheel below each
vent. This sends more warm air to
the windshield defroster vents. Once
the windshield is clear, select fresh
air mode to avoid fogging the
windows.
For your safety, make sure you have
a clear view through all the windows
before driving.
Table Of Contents
To Cool or Heat Automatically
The automatic climate control
system adjusts the fan speed and
airflow levels to maintain the interior
temperature you select.
On models with navigation system
In AUTO mode, the vehicle's interior
temperature is independently
regulated for the driver and
passenger. If the driver's side of the
vehicle is getting too much sun, the
system will adjust to a lower
temperature.
Using Automatic Climate Control
1. Press the AUTO button.
2. Set the desired temperature with
the temperature control buttons.
You will see AUTO in the system's
display.
2008 TL

Climate Control

When the AUTO button on the
driver's side is pressed, the
temperature control buttons on the
passenger's side are disabled, and
the interior temperature is regulated
to the temperature set on the driver's
side. When the AUTO button on the
passenger's side is pressed,
temperature can be set on the driver's
side and passenger's side separately.
The system automatically selects the
proper mix of conditioned and/or
heated air that will, as quickly as
possible, raise or lower the interior
temperature to your preference.
When you set the temperature to its
lower or its upper limit, the system
runs at full cooling or heating only. It
does not regulate the interior
temperature.
CONTINUED
131