Operating Controls; On/Off Switch; Maintenance; Motor Maintenance - KNOVA KN CP-1041B Manual

OPERATING CONTROLS

For operator safety, before operating the machine, make
certain that dust intake hose is always attached to the dust
intake port. The rotating fan located inside the blower housing
is accessible through the dust intake port and can
be hazardous.
Always wear proper apparel. Do not wear jewelry and keep
fingers and all foreign objects out of the dust intake port.
Follow the safety rules earlier in this manual.

MAINTENANCE

NOTE : Before any maintenance or service is performed, be
sure the dust collector is disconnected from the power source
to prevent accidental starting and the safety gates closed.
All maintenance other than the items recommended in this
manual should be performed by an authorized Service Center.
1. IMPORTANT : Always disconnect the machine from the
power source before performing any maintenance
procedures.
2. The condition of the dust bag should be checked
periodically for damage and emptied on a regular basis.
Do not transport the machine with a full dust bag.
3. Clean and apply a dry silicone lubricant monmthly
to the impeller to remove any dirt or build-up of pitch,
gum and wood shavings

PARTS LIST

Part No. D e s c r i p t i o n
1 Base
2 Caster
3 Nut
4 Collector body
5 Hex. head screw
6 Impeller washer
7 Impeller
8 Hex. head screw
9 Hex. head screw
10 Washer
11 Inlet cover
12 Hex. head screw
13 Motor packing
14 Key
15 Motor
The on/off switch is located on the side of the motor.
To turn the dust collector "ON", push switch upward.
To turn dust collector "OFF", push switch downward.
Removing dust and dirt : Blow off motor with low pressure
air to remove dust or dirt. Air pressure above 50 P.S.I.
should not be used as high pressure may damage insulation
and blow dirt under loosened tape. The operate peforming
this cleaning function should always wear eye protective
goggles. Dusk can cause excessive insulation temperatures.
Specification Q'ty.
1
5/16" 4
5/16" 4
1
M6 x 20 1
1
1
5/16" x 5/16" 1
1/4" x 1/2" 4
1/4" x 25 4
1
M5 x 10 12
1
1
1
6

ON/OFF SWITCH

MOTOR MAINTENANCE

WIRING DIAGRAM

120 volt
Black 3 Yellow 2
White 1 Red 4
Part No. D e s c r i p t i o n
16 Handle
17 Handle cap
18 Phillip head screw
19 Sponge
20 Supporting leg
21 Hex. head screw
22 Supporter
23 Hanger
24 Upper filter bag
25 Bottom collecting bag
26 Power cord
27 Switch
28 Open end wrench
29 Washer
240 volt
Black 3 Yellow 2
White 1 Red 4
Specification
Q'ty.
1
5/8" 2
5/16" x 1" 2
1
2
5/16" x 12" 12
1
1
1
1
1
1
10 - 12 mm 1
5/16" x 18 4