Failure To Follow These Rules May Result In Serious Personal Injury; Important Safety Rules For Dust Collectors - KNOVA KN CP-1041B Manual

WARNING

FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY

1. FOR YOUR OWN SAFETY, READ INSTRUCTION
MANUAL BEFORE OPERATING THE TOOL. Learn
the tool's application and limitations as well as the
specific hazards peculiar to it.
2. KEEP GUARDS IN PLACE and in working order .
3. ALWAYS WEAR EYE PROTECTION.
4. GROUND ALL TOOLS. If tool is equipped with
three-prong. If an adapter is used to accommodate a
two-prong receptacle, the adapter lug must be attached
to a known ground. Never the third prong.
5. REMOVE ADJUSTING KEYS AND WRENCHES.
Form habit of checking to see that keys and adjusting
wrenches are removed from tool before turning it "on".
6. KEEP WORK AREA CLEAN. Cluttered areas and
benches invite accidents.
7. DON'T USE IN DANGEROUS ENVIRONMENT.
Don't use power tools in damp or wet locations, or
expose them to rain. Keep work area well-lighted.
8. KEEP CHILDREN AND VISITORS AWAY. All
children and visitors should be kept a safe distance
from work area.
9. MAKE WORKSHOP CHILDPROOF-with padlocks
master switches, or by removing starter keys.
10. DON'T FORCE TOOL. It will do the job better and
be safer at the rate for which it was designed.
11. USE RIGHT TOOL. Don't force tool or attachment
to do a job for which it was not designed.
12. WEAR PROPER APPAREL. No loose clothing, gloves,
neckties, rings, bracelets, or other jewelry to get caught
in moving parts. Nonslip footwear is recommended.
Wear protective hair covering to contain long hair.
13. ALWAYS USE SAFETY GLASSES. Wear safety
glasses. Every eyeglasses . Also use face or dust
mask if cutting operation is dusty.
14. SECURE WORK. Use clamps or a vise to hold work
when practical. It's safer than using your hand and
frees both hands to operate tool.

IMPORTANT SAFETY RULES FOR DUST COLLECTORS

WARNING: Basic precautions should always be followed
when using your dust collector. To reduce the risk of injury,
electrical shock or fire, comply with the safety rules listed
below:
1. READ and understand the instruction manual before
operating the dust collector.
2. DO NOT leave the dust collector plugged into the
electrical outlet. Unplug dust collector from the outlet
when not in use and before servicing, changing bags,
unclogging and cleaning.
3. ALWAYS turn the power switch "OFF" before
unplugging the dust collector.
4. WARNING : TO REDUCT THE RISK OF ELECTRICAL
SHOCK do not use outdoors nor on wet surfaces. Use
for dry pickup only!
5. FOLLOW all electrical and safety codes, including the nat
ional Electric Code and the national regulation.
Qualified personnel should make all electrical
connections and wiring only.
15. DON'T OVERREACH. Keep proper footing and
balance at all times.
16. MAINTAIN TOOLS IN TOP CONDITION. Keep tools
sharp and clean for best and safest performance. Follow
instructions for lubricating and changing accessories.
17. DISCONNECT TOOLS before servicing and when
changing accessories such as blades, bits, cutters, etc.
18. USE RECOMMENDED ACCESSORIES. The use
of accessories and attachments no recommended
by us may cause hazards or risk of injury to persons.
19. REDUCE THE RISK OF UNINTENTIONAL
STARING. Make sure switch is in "OFF" POSITION
BEFORE PLUGGING IN POWER CORD.
20. NEVR STAND ON TOOL. Serious injury could occur if
the the tool is tipped or if the cutting tool is accidentally
contacted.
21. CHECK DAMAGED PARTS. Before further use of the
tool a guard or other part that is damaged should be
carefully checked to ensure that it will operate properly
and perform its intended function-check for alignment
of moving parts, binding of moving parts, breakage
of parts, mounting, and any other conditions that may
affect its operation. A guard or other part that is
damaged should be properly repaired or replaced.
22. DIRECTION OF FEED. Feed work into a blade or
cutter against the direction of rotation of the blade
or cutter only.
23. NEVER LEAVE TOOL RUNNING UNATTENDED.
TURN POWER OFF. Don't leave tool until it comes
to a complete stop.
24. DRUGS, ALCOHOL, MEDICATION. Do not operate tool
while under the influence of drugs,alcohol or any
medication.
25. MAKESURE TOOL IS DISCONNECTED FROM
POWER SUPPLY while motor is being mounted,
connected or reconnected.
6. DO NOT use the dust collector to pick up flammable or
combustible dust/gas such as gasoline. NEVER use the
dust collector near any flammable or combustible liquids.
7. USE the dust collector to pick up wood materials only.
DO NOT use the dust collector ti pick up metal shavings,
dust, water, or parts.
8. NWVWE use the dust collector to dissipate fumes or
smoke. NEVER pick up anything that is burning or
smoking, such as cigarettes, matches or hot ashes.
9. USE only as described in this manual.
10. DO NOT pull the dust collector by the power cord.
NEVER allow the power cord to come contact with
sharp edges, hot surfaces, oil or greas.
11. DO NOT unplug the dust collector by pulling on the
power cord. ALWAYS grasp the plug no the cord.
12. DO NOT handle the plug or dust collector witch wet
hands.
2