Electrical Requirements; Unpacking - KNOVA KN CP-1041B Manual

IMPORTANT SAFETY RULES FOR DUST COLLECTORS
13. REPLACE a damaged cord immediately. DO NOT use a
damaged cord or plug . If the dust collector is not
operating properly, or the been damaged left outdoors or
has been in contact with water return it to an Authorized
Service Center for service.
14. DO NOT use the dust collector as a toy. DO NOT use
near or around children.
15. DO NOT insert fingers or foreign objects into the dust
intake ports. Keep hair, loose clothing fingers, and all
body parts away from opening and moving parts of
the dust collector.
16. DO NOT use the dust collector without than filter bag
and dust collector bag in place and properly secured.

ELECTRICAL REQUIREMENTS

Check that the power source used is in accordance with your
tool. Have a look at the nameplate of the motor.
If this product is equipped with a single phase motor, it is
supplied with a 3-conductor cord and molded grounding type
plug that looks like the picture (a3) isthis product is bought
in other countries (Austria, Belgium, France, Germany, ltaly,
Luxembourg, Netherland, Spain).
Do not modify the plug provided. If it does not fit with the
outlet, have the proper outlet installed by a qualified
electrician. If the power cord is worn or cut or damage in any
way, have it replace immediately. The ground conductor has a
green and yellow stripe jacket and is attached to the tool
housing at one end and to the ground prong in the attachment
plug at the other end.
WARNING
This machine must be earthed.
If not properly earthed this power tool can cause an electrical
shock. Be sure that your outlet is earthed. If any doubt have it
check by a qualified electrician. Also avoid contact with
earthed surfaces, as plumbing, to protect yourself against
electric shock.
WARNING
Do not permit fingers to touch the terminals of plug
when installing (removing) the plug to (from)
the outlet.
The use of any extension cord
will cause some loss of power.
To keep this to a minimum and
to prevent overheating and
motor burm-out, ask advice to
a qualified electrician to
determine the minimum wire
size extension cord.
The extension cord should be
equipped with a grounding
type plug that fist the outlet
at one end, and with a
grounding type plug socket
that fits power tool plug at
the other end.
All connections should
be correct.
17. DO NOT operate the dust collector with unused dust
intake ports uncapped. ALWAYS cover exposed dust
intake ports.
18. PERIODICALLY INSPECT dust and filter bags for any
cuts, rips or tears. NEVER operate the dust collector
with a damage bag or vacuum hose.
19. The dust collector is designed for home use or industrial
duty ONLY!
20. CONNECT dust collector to a properly grounded outlet
only. See grounding instruction
SAVE THESE INSTRUCTIONS

UNPACKING

Carefully unpack the dust collect from the shipping container.
WARNING : DO NCT CONNECT THE DUST COLLECTOR
TO THE POWER SOURCE UNTIL THE MACHINE IS
COMPLETELY ASSEMBLED AND YOU HAVE READ AND
UNDERSTAND THE ENTIRE OWNER'S MANUAL.
Figures 2 illstrates the components after they are removed
from the shipping container.
D
F
I
A. Base plate
B. Collector body with motor
C. Upper bag support
D. Handle bar
E. Two collector support
a3
3
C
E
G
H
J
F. Collector support
G. Filter bag
H. Collector bag
I. Screws and washers
J. For caster
B
A
Fig. 2