Advertisement
Ensure the Side Panels are flush
mounted on top of the Bracket LH & RH,
as shown, and the bolts tightened fully
Step 4:
Slip in the Spacer (3) – 4 off in between the
Bracket LH/RH and the Rear Rack and slip-in the
Washer M6 (6) and Screw M6 x 25 (7) through the
Mounting holes in the Rear Rack and Brackets and,
secure from the bottom, using the Nuts (M6) (8) –
4 off and tighten it to the torque as shown in the
BOM table
Rear Rack as shown "Final
Assembled condition"
Copyright By SRC
Design and Specification are subjected to change
Page 4
Advertisement
