Battery Instructions; Optional Power Supply - Tork 461123 Manual

Hand towel dispenser in-wall recessed with intuition sensor
Table of Contents

Advertisement

WARNING – RISK OF INJURY TO PERSONS
When using electric appliances, basic precautions should always be followed, including
the following:
a)
Read all the instructions before using the appliance
b)
To reduce the risk of injury, close supervision is necessary when an appli
ance is used near children
c)
Do not contact moving parts
d)
Use only attachments or accessories recommended or sold by the manu
facturer
e)
Do not use outdoors
OPERATIONAL ENVIRONMENT AND STORAGE
This dispenser is not suitable for installation outdoors or in wet environments. It is not wa-
ter-resistant. Under no circumstances should the dispenser be hosed-down or contacted
by a water jet. To ensure proper function, the dispenser must be installed in an environ-
ment with minimum and maximum ambient temperatures between 41 and 86°F (5 – 30°C).
The dispenser should acclimate at these temperatures for 24 hours prior to installation.

BATTERY INSTRUCTIONS

Dispenser shall be powered with three (3) D type alkaline batteries. Do not use re-charge-
able batteries. For optimal performance, batteries should be stored at temperatures
between 41 and 86°F (5 – 30°C). Do not mix batteries from different manufacturers. Do
not mix batteries with different date codes. Do not mix new and used batteries. Three
(3) batteries are to be inserted in the door of the clear battery compartment with positive
terminal facing up. When batteries have been exhausted, they must be removed from the
dispenser and safely disposed. If the dispenser is unused or unopened for a long period
of time, the batteries should be removed. The supply terminals are not to be short-circuit-
ed. For battery installation, see Figure 2 on page 15 of the operating instructions.

OPTIONAL POWER SUPPLY

An optional manufacturer-supplied plug-in power supply is available. Order SCA part num-
ber 551102. This accessory must be installed according to the instructions provided with
the article assembly. Failure to use the manufacturer's power supply, or to follow instruc-
tions, presents a risk of electrical shock, may result in destruction of the dispenser and/or
its software, and presents significant risk of injury or property damage. Important - bat-
teries must be removed prior to connecting manufacturer's power supply to an electrical
outlet.
INSTALLATION ALERT
Do not install the Product until you have read this entire document. This document sets
forth the term and conditions for the use and installation of the Product. Commencing
installation of this Product indicates that the Buyer has read and understands this agree-
ment and accepts its terms and conditions.
1
IMPORTANT SAFETY INSTRUCTIONS
MODEL: 461123

Advertisement

Table of Contents
loading

Table of Contents