Specifications; Important Safety Information - KNOVA KN 7420-12 Manual

SPECIFICATIONS

TECHNICAL DATA
Working load limit
Working range

IMPORTANT SAFETY INFORMATION

The use of a Hydraulic Press has inherent
dangers to avoid risk of personal injury
or property damage make sure you are
fully aware of the operating instructions
for this product, the recommendations in
this manual can not cover all eventualities
this press is designed and intended for
use by properly trained and experienced
personnel. If you are not familiar with the
proper and safe operation of a hydraulic
UNPACKING AND ASSEMBLING HYDRAULIC PRESS
Unpacking Carton
Place carton in a clear, open area such as
garage floor. Remove pieces from carton,
caution this press is heavy please do not
attempt assembly on you own seek
appropriate assistance.
Assembly
Place frames press # 19 upside down
and keep them vertical. Secure the cross
brace # 18 and # 24 support base on one
side of the press frame. Set the opposite
side of the cross brace at the other end
of the press frame and other support
base; tighten all screws firmly. Stand up
the press on the support bases and make
sure the press is stable before proceeding
with the assembly.
Attach return springs # 14 to the top
beam # 23. Locate jack plate # 22 and
parallel to the top beam position it. Insert
it angled and then upload it in parallel.
Attach return springs to hold the jack
plate in position.
Insert the press plates # 20 in angle and
parallel, hold them in place with the
support pins # 17, make sure that the
press plates are parallel by placing the
support pins into the holes at the same
height.
Position jack on jacking plate by placing
top of jack into the retaining ring on the
main cross beam, then push the jack
slowly to depress the return springs – jack
is properly installed when base of jack and
jacking plate are in parallel.
KN 7420-12
12,000 Kg
24-13/16"
Working width
Net Weight
press, do not use until proper training and
knowledge has been obtained.
Do not exceed working load limit of this
press. This Press is intended for pressing,
bending, and straightening purposes only.
Do not use for any other purpose accept
those listed in this manual, never use to
compress springs or other objects that
could be ejected from the press. Do not
compress objects that could shatter.
Recheck all bolts and nuts are tight and
that the assembled press is stable.
Ensure jack base is parallel with jack
plate. Recheck jack plate springs are
properly installed and that pins are full
inserted at the same height to ensure the
plate is parallel.
15-3/4"
45.7 Kg