Yellowtec iXm Getting Started page 5

PC connection
Connect the device to the PC by plugging-in the USB-Cable. The BAT indicator will start
blinking slowly yellow indicating that the internal Li-Ion accumulator battery will be charged.
Note: the physical USB connection does not cause any data transfer between device and
PC. There are two different modes of establishing a data connection between device and
PC.
iXm in flash mode
Press and hold RWD and STOP buttons on the playback keypad to enter iXm s flash mode
indicated by a yellow MEM LED. The device s memory (SD card) can now be accessed as
external flash memory from the PC.
Press and hold RWD and STOP buttons again to release iXm s flash mode until the MEM
indicator switches off.
iXm in setup mode
Press and hold FWD and STOP buttons on the playback keypad to enter iXm s setup mode
indicated by a red MEM LED. This mode will be used for configuration of iXm or to obtain
status information running admin and respectively user software that both belong to iXm s
scope of delivery.
Press and hold FWD and STOP buttons again to release iXm s setup mode until the MEM
indicator switches off.
Note: the device will perform a memory check indicated by red blinking MEM LED when
releasing flash or setup mode.
iXm Getting Started. Yellowtec 10-2009. Page 5 of 6