Switch Off - Yellowtec iXm Getting Started

Switch on
Press and hold the Stop button on the playback keypad and the Record button on the record
keypad simultaneously for about 1 second.
Record Keypad
iXm will start booting. The boot process is indicated by a fast green blinking REC indicator.
When booting is completed, iXm will perform a memory check indicated by a fast red
blinking MEM indicator.
Note: a successfully completed memory check will cause the MEM indicator to stop blinking.
If the MEM LED does not stop blinking after a few seconds, the SD memory card is not read
correctly. Please make sure that the card is inserted properly.
The device is now ready for record indicated by a red flashing REC indicator every 2
seconds.

Switch off

Press and hold the Stop buttons on record and playback keypad simultaneously. The device
will switch off immediately. All indicators will shut off.
Record Keypad
iXm Getting Started. Yellowtec 10-2009. Page 2 of 6
Playback Keypad
Playback Keypad