Advertisement
Parts and accessories
1. Handle
2. Control panel
3. Operating hour meter
4. Air filter
5. Condensate collecting container
6. Adapter for continous drain. Placed in the
condensate collection container.
Storage
If the unit not is used for an extended period of
time. Please:
Turing the unit off and unplug the cord set.
Completely empty the water tank and wipe it
clean.
Cover the unit and store where it will not
receive direct sunlight.
Keeping od more than one dehumidifier
Make sure that the rubber feet are placed in the
hollows. NOTE! A maximum of two units can be
placed on top of each other.
5
SUN30
Control panel
1. Plug the unit into a 230V earthed socket.
2. Press the ON/OFF button to turn on the
unit. The dehumidifier will start to work in
CONT mode (dehumidifies continously). If the
dehumidifier isn´t turned off by the ON/OFF
button or has been turned off for at least 3 min.
the start of the compressor will be delayed for
3 min.
3. Press button HUM to set the room humidity
you require: continuous de-humidifying, 40%,
50%, 60% or 70%. When the room humidity is
under 35%, the display will show 'LO' and if the
room humidity is over 95%, it will show 'HI'. If
the fan speed HI is selected, it will change to LO
when the compressor stops and change to HI
again when the compressor starts.
4. Press the speed button to choose the
ventilation speed, high or low.
5. Press the timer button to set the time
for operation (1~24hr). The unit will be
continuously de-humidifying if no time is set.
6. To turn off the unit, press the ON/OFF button
again.
1 Timer (button, adj. 1-24 hours)
2 Timer operation indicator
3 Humidity selection button
4 Humidity indicator
5 "WATER FULL" indicator
6 Low speed indicator
7 Speed (ventilation)
8 High speed indicator
9 ON/OFF(power) indicator
10 ON/OFF button
11 Display window (displays hum.)
Advertisement
