Optional: Pairing with Safera Power This guide describes the use, installation Control (PCU) and maintenance of the three versions of Maintenance the product: Unicook Airis BT, Airis WiFi Troubleshooting and Airis AQ. Technical Specifications For private households in EU: Before reading, please check the Safera...
Follow instructions marked with a warn- do not disassemble the product. Con- ing accurately to prevent injury to per- tact Safera for all service needs. sons and damage to property. Unicook stove guard controls the stove and/or oven only if it is equipped and ⚐...
Page 4
2.3 Battery Safety Information 2.4 Laser Safety Information ѥ WARNING The Unicook Airis AQ contains two laser light sources: Failure to follow the instructions below may cause the batteries to leak fluid and 1. Class 1 laser as part of the optical dis- gas, or even explode: tance and gesture detection system.
Yes, Battery low cooking situation. blinking three times pitch The Safera mobile app must be used if the 3-tone Sensor is not to be mounted at the height Blue The sensor set as the factory default (see chapter 4.4). blinking,...
4. Installation 4.1 Check the Delivery Contents The following components should be in- ❸ cluded: 1. Sensor unit and batteries (3 x AA) ❷ 2. Wall mount bracket (pre-installed) 3. Cooker hood mount bracket (not installed) 4. This user manual ❶...
Page 7
4.2 Installation of Power Control Units (Optional) PCU6.3-F Fixed 3-phase connection. See pages 8-9. PCU6.1-F Fixed 1-phase connection. See pages 10-11. PCU10.2.-F 2-phase connection with fixed installation. See pages 12-17.
Page 8
PCU6.3-F - Installation Fixed 3-phase connection. 78 mm 60 mm 225,5 mm 42 mm MICRO DISCONNECTION ѥ WARNING The PCU can be installed behind an oven below a hob, under a plinth or in a kitch- Turn the power off at the isolation switch en cupboard.
Page 9
Phase order can be freely chosen. If only two phases are used, connect them to the terminals L1 and L2.
Page 10
PCU6.1-F - Installation Fixed 1-phase connection. 78 mm 60 mm 225,5 mm 42 mm 230 V MAX. 35 A MICRO DISCONNECTION ѥ WARNING The PCU can be installed behind an oven below a hob, under a plinth or in a kitch- Turn the power off at the isolation switch en cupboard.
Page 12
PCU10.2-F - Installation 2-phase connection with fixed installation. 195 mm 122 mm 63 mm L2/N L2/N 208-240 V MAX. 50 A 50-60 Hz ѥ WARNING The PCU can be installed behind an oven below a hob, under a plinth or in a kitch- Turn the power off at the isolation switch en cupboard.
Page 13
Mount the Take off power control fuses to unit Ⓒ on the the stove. wall behind the cooker or into the cabi- net next to Remove the the cooker. cover to access internal wiring. Connect the stove plug to the Ground wire is power control connected to...
Page 14
4.3 Power up the Sensor Unit 4.4 Mount the Sensor Unit Detach the wall mount bracket to uncov- There are two alternative mounting loca- er the battery compartment by pulling it tions: gently open. The bracket is held in place by magnets.
Page 15
For the most up to date mounting method enclosure. and stove support information, please re- fer to the “Installation Wizard” -section in The maximum supported stove width is the Safera App. For the factory shipped 90cm. software version, the allowed mounting height specifications are: Cooker hood Sensors’...
Page 16
Bluetooth 1. Select the most suitable mounting method and place the appropriate Please install the Safera App to your mo- mounting bracket on the sensor unit. bile phone. The App is needed for initial 2. Make sure that there is no obstruction setup, firmware updates, configuration in the sensors’...
The Power Control Unit will now 5. Working order checked successfully: contact the Sensor unit which gives a sound signal (•••). 5. Open Safera App and go to the “Install a new Safera Sense” section (this section Date Installer...
6. Maintenance 6.3 Battery replacement High-capacity batteries are recommend- ed such as Varta Industrial. 6.1 Regular maintenance Remove the sensor unit from the mount- To ensure continued safe and reliable op- ing bracket by pulling it gently. eration, follow these maintenance instruc- tions at least once every three months or Remove the empty batteries.
Control Unit over- Faulty installation re-run the "Installation heating. position of the Wizard" in the Safera sensor unit: see App to make sure that remedy on the all kitchen and cooker table below. related parameters are...
• 802.11 g: +17 dBm designated collection point. Penalties may • 802.11 n: +14 dBm be applicable for incorrect disposal of this waste, in accordance with your national Safera Wireless (Proprietary legislation. protocol for PCUs) • Range: 10 … 20 meters depending on construction materials presence •...
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s author- Safera Oy declares that Sense is in compli- ity to operate the equipment. ance with the following EU directives and Class B device notice standards.
IS NOT A SAFETY PRODUCT AND IS NOT cense Terms and Conditions (“Terms”) INTENDED TO PREVENT ACCIDENTS. YOU between you (“You”) and Safera Oy (“Saf- EXPLICITLY AGREE AND UNDERSTAND era”). Please read these Terms carefully THAT THE PRODUCT, THE SAFERA AP-...
Page 23
(a) copied or other- FUNCTIONING OF THE PRODUCT AND/ wise reproduced (possible reinstallation OR THE SAFERA APPLICATION AND/OR shall be performed by Safera or a repair A COMPATIBLE POWER CONTROL UNIT, shop authorized by Safera), (b) modified, WHETHER DIRECT OR INDIRECT, SPECIAL,...
Page 24
You and the Distributor and on other terms ap- plicable between You and the Distributor. Safera is not bound by any such terms or any other terms of the Distributor. 11.5 General If any provision of these Terms is held to...
Need help?
Do you have a question about the Airis BT and is the answer not in the manual?
Questions and answers