Sharp PN-Q901 Setup Manual page 31

Remote Control Unit
1
2
3
Remote control sensor
30°
17´ (5 m)
30°
30°
30°*
*: The angle is 6° when the stand
is attached. (for PN-Q901 only)
Installing Batteries in the
Remote Control Unit
If the remote control fails to operate Monitor
functions, replace the batteries in the remote
control unit.
1
Open the battery cover.
2
Insert two "AAA" size batteries
(supplied with the product).
• Place the batteries with their terminals
corresponding to the (+) and (–)
indications in the battery compartment.
3
Close the battery cover.
CAUTION
Improper use of batteries can result in chemical
leakage or explosion. Be sure to follow the instructions
below.
• Do not mix batteries of different types. Different
types of batteries have different characteristics.
• Do not mix old and new batteries. Mixing old and
new batteries can shorten the life of new batteries
or cause chemical leakage in old batteries.
• Remove batteries as soon as they are worn out.
Chemicals that leak from batteries that come in
contact with skin can cause a rash. If you find any
chemical leakage, wipe thoroughly with a cloth.
• The batteries supplied with this product may have a
shorter life expectancy due to storage conditions.
• If you will not be using the remote control unit for
an extended period of time, remove batteries from
it.
Using the Remote Control Unit
Use the remote control unit by pointing it towards
the remote control sensor on the Monitor.
Objects between the remote control unit and
the remote control sensor may prevent proper
operation.
■ Cautions regarding the remote
control unit
• Do not expose the remote control unit to shock.
In addition, do not expose the remote control unit
to liquids, and do not place it in an area with high
humidity.
• Do not install or place the remote control unit under
direct sunlight. The heat may cause deformation of
the remote control unit.
• The remote control unit may not work properly if
the remote control sensor on the Monitor is under
direct sunlight or strong lighting. In such cases,
change the angle of the lighting or the Monitor, or
operate the remote control unit closer to the remote
control sensor.
IMPORTANT:
IF THE UNIT DOES NOT POWER ON - UNPLUG
THE MONITOR FROM THE OUTLET AND
REPEAT THE INSTALLATION STEPS.
EN 6
Connection
Types of Connection
For connecting the Monitor to external equipment, use commercially available cables.
• The illustrations of the terminals are for explanation purposes and may vary slightly from the actual products.
■ Connecting to video equipment or PC
■ Image quality differs depending on the terminal used. To enjoy clearer images, check the output terminals
of your external equipment and use its appropriate terminals for higher quality images.
Image Terminal on the
Quality Monitor
HDMI-certified cable
HD
Quality
Ø 3.5 mm stereo minijack cable
HDMI-certified cable
Component video cable
Audio cable
Standard
Quality
AV cable
■ Connecting to audio equipment
Check the output terminals of your external equipment and use its appropriate terminals.
Terminal on the Monitor
Optical fiber cable
Terminal on external
Cable
equipment
AUDIO
Terminal on external
Cable
equipment
OPTICAL
DIGITAL AUDIO INPUT
Audio cable
ANALOG AUDIO IN
Pages
EN 7, EN 8
EN 8
EN 7
EN 7
Pages
EN 8
EN 8