Panasonic Lumix DMC-G1KPP Service Manual page 35

• 5. How to read the error code:
One error code is displayed for 8 bit, the contents of error codes is indicated the table as shown below.
Attribute Main item
LENS Lens
HARD VENUS A/D
FLASH ROM
SYSTEM IC
SOFT CPU
Recording
Media
Lens
Camera
System
About "*" indication in the above table:
The third digit from the left is different as follows.
- In case of 0 (example: 18001000)
When the third digit from the left shows "0", this error occurred under the condition of INITIAL SETTINGS has been com-
pleted.
It means that this error is occurred basically at user side.
- In case of 8 (example: 18801000)
When the third digit from the left shows "8", this error occurred under the condition of INITIAL SETTINGS has been
released.
(Example; Factory assembling-line before unit shipment, Service mode etc.)
It means that this error is occurred at service side.
• 6. How to returned to Normal Display:
Turn the power off and on, to exit from Error code display mode.
NOTE:
The error code can not be initialized.
Sub item Error code
High 4 bits Low 4 bits
Communication 18*0
Flash 28*0
Data Area 2B*0
Program Area
Initialization 2C*0
Reset 30*0
SD Memory 31*0
Card
ZOOM 3C*0
System 3B*0
3E*0
System 35*0
35*1,
35*2
0000 Lens communication error.
|
FFFF
0000 Flash charging capacitor did not been fully charged within 20 seconds.
0001 Flash ROM data reading error is detected when the unit turns ON.
0002 Flash ROM data writing error is detected when the unit turns OFF.
0005 Firmware update error.
0001 Clock IC initialization failure error.
0001 System error (NMI reset).
|
FFFF
0001 SD memory card logic error.
SD memory card format error.
When it is detected, [MEMORY CARD ERROR FORMAT THIS CARD?]
is displayed on the screen.
0002 SD memory card physical error.
During formatting the SD memory card, there is no response from the
card.
If the mini-SD memory card is used, check the SD memory card adaptor.
0004 SD memory card writing error.
Check the SD memory card. It might be damage one.
0000 Zoom process does not be completed.
0000 Initialization failure.
0001 Exposure charging operation failure.
0002 Failure of the returning operation to the home position.
0001 System error.
|
FFFF
0000 System error (in recording pre-process).
35
Contents