Advertisement
10. Attach Score Beads to Top Plate
12.Take 2 bearing halves (#1 and #2) and
connect them over rod and then place them
into wall by aligning tabs with openings in
the side of wall opening.
Wipe rods down with cloth or napkin
then add 1 or 2 drops of silicone
Assembly Pictures
13.Slide bearing nut over handle & tighten
14.On rod side install Rod Guard Bearing
and tighten fully
www.WarriorTableSoccer.com
11.Guide handle through opening in near
wall in proper position. Pull all the way in
to allow other end of rod to clear far wall.
Level table by turning leg levelers to
raise or lower legs as needed
8 |
P a g e
Advertisement
