Advertisement
Quick Links
Advertisement
Related Manuals for XpressFill XF460
Summary of Contents for XpressFill XF460
- Page 1 XpressFill XF460 / XF260...
- Page 3 Do not use the bottle filler covered in this manual unless you are certain the electrical supply has been correctly installed and the bottle filler has been properly grounded. 265 Prado Road, Suite 1 | San Luis Obispo, CA 93401 | 805.541.0100 | xpressfill.com | sales@xpressfill.com...
- Page 4 Safety Warnings...
- Page 5 The guarantee may be rendered invalid if the customer has made repairs or alteration to the machine without first consulting XpressFill Systems LLC. 265 Prado Road, Suite 1 | San Luis Obispo, CA 93401 | 805.541.0100 | xpressfill.com | sales@xpressfill.com...
- Page 6 3. Plug the filler into a wall outlet. Turn on the Power Switch. The Digital Timer shows time in seconds. Note: A power conditioned/surge protector is highly recommended. Power cord receptacle/ fuse/spare fuse (see page 12) 265 Prado Road, Suite 1 | San Luis Obispo, CA 93401 | 805.541.0100 | sales@xpressfill.com...
- Page 7 If the filler is equipped with the gas option, simply press the Gas button for as long as desired; approximately 35 seconds for a 750ml bottle. 265 Prado Road, Suite 1 | San Luis Obispo, CA 93401 | 805.541.0100 | sales@xpressfill.com...
- Page 8 The recommended pressure is 20 - 30 psi. To flush your bottle, simply push the “Gas” button for the desired length of time (1-3 seconds) before you start the fill cycle. 265 Prado Road, Suite 1 | San Luis Obispo, CA 93401 | 805.541.0100 | sales@xpressfill.com...
- Page 9 Uneven Fill Levels Please note that the XF460/260 is a volumetric filler, not a level filler. You might encounter different fill lines in your bottles due to differences in your bottles. Your bottle might have the same weight, but have slight variances in wall thickness, neck size, punt, etc.
- Page 10 Before storing your XpressFill, flush your filler with 2 gallons of warm water. Be sure you get all water out of the flow path. This is done by continuing to run the pump until it runs dry. In order to get the last of the water out of the filler, carefully tip the filler upside down several times to allow all liquid in the flow path to empty.
- Page 11 A tool is included with the filler and can be found inside the filler. Collet Push collet in with tool to remove hosing 265 Prado Road, Suite 1 | San Luis Obispo, CA 93401 | 805.541.0100 | xpressfill.com | sales@xpressfill.com...
- Page 12 There is a spare fuse in the power cord receptacle. Unplug the machine and set a screwdriver on the notch (do not remove screws) and pop the spare fuse holder toward you, then replace the fuse. XpressFill Part No. 200002 –...
- Page 13 13 | XpressFill Systems LLC Accessory Kit 265 Prado Road, Suite 1 | San Luis Obispo, CA 93401 | 805.541.0100 | xpressfill.com | sales@xpressfill.com...