Operating The Unit; Changing The Air Filter - iHerz iFlow User Manual

EN
and cover together. Make sure that the two parts
B C
fit securely (figure C). The stem inside the medi-
cation cup inserts into the cap's neck.
5. Connect one end of the air tube to the medi-
cation cup and the other end to the connector
on the device (figure D).
D
E
6. Install the needed accessory on the medicine
cup: adult or pediatric mask, or mouthpiece (fig-
ure E). Note: The mouthpiece is to be used for
oral inhalation only.

Operating the Unit

To operate the Nebulizer, do the following:
• Plug in the compressor but do not connect the nebulizer kit yet. Make
sure that the air filter is attached to the compressor.
• Turn on the power switch.
• After the compressor runs properly for 1-2 minutes, connect the jet outlet
of the compressor to the inlet of the nebulizer kit by the air hose.
• Begin treatment according to your physician's instructions. Inhale and
exhale naturally. Be sure to stop when the medicine is used up.
• When you have finished, turn the compressor unit off before
you disconnect the air hose.

Changing the Air Filter

The filter should be replaced after 100 hours
of use or when it turns grey. For filter replac-
ing, carefully pull the lid out of its housing.
Remove the old filter and fit in a new one.
Install the filter holder back in its hous-
ing, making sure that it is securely fixed.
Use the filters supplied by the manufacture only.
RECOMMENDATIONS FOR CARRYING OUT NEBULIZING THERAPY:
• Sit down in a comfortable and upright position.
• If a mask (adult or pediatric) is used, be sure that it securely adheres
to the face. Mask has holes for the air flow during the expiration.
11