Advertisement
12
www.raider.bg
damaged cutters immediately.
▪ Only use milling cutters with a suitable tail
diameter and corresponding to the rotational
speed of the power tool.
▪ Before starting work, remove from the
workpiece all nails, screws and
other bodies. When cutting into a nail or other
metal body can damage the router and
power tool, which is a prerequisite for
occupational accident.
▪ Always guide the sander using both handles and
make sure you hold the machine firmly before
starting any operation.
▪ Keep your hands away from the rotary cutter.
▪ Before turning on the machine, make sure that
the milling cutter does not touch the machined
surface.
▪ Before starting work on the machine, first switch
it on and let it idle.
Be alert for vibrations or beating
may be an indication of incorrect placement
milling machine.
▪ Pay attention to the direction of rotation
of the milling cutter and of the feed direction.
▪ Do not leave the machine unattended.
Only operate the power tool if it is
hold firmly with both handles.
▪ Always switch off the power tool and
wait until the rotation stops completely
the router before pulling the machine away from
the workpiece.
▪ Do not touch the cutter immediately after
stopping
renewal of work with it. The milling machine can
be very hot and get burned
the skin.
▪ The presence of
rags, towels, tow, twine, cords, etc.
The power tool must only be used for its intended
purpose. Any use other than that described in
this manual will be considered improper use. The
responsibility for any damage or injury resulting
from improper use will be borne by the user and
not by the manufacturer.
The manufacturer is not liable for any changes
made by the user to the power tool or for damage
caused by such changes.
Even when the power tool is used as intended, it
is impossible to eliminate all residual risk factors.
The following hazards may arise in connection
with the design features and design of the power
tool:
▪ Hearing impairment if not worn effectively
antiphons.
▪ Release of harmful dust when
the machine is used indoors.
Always use an extra dust extractor.
Warning: common
hazards during grinding, grinding
or abrasive cutting:
▪ This power tool is suitable
for sanding, brushing or polishing.
Read all warning instructions, illustrations and
specifications,
provided with this power tool.
Failure to follow all instructions may
result in electric shock, fire and / or severe
injuries.
▪ It is not recommended to perform
operations such as grinding or cutting
with carboflex washers with this
power tool. Performing
operations for which the power tool is not
designed can create danger and yes
causes of injuries.
▪ Do not use accessories that are not
specially designed or recommended
from the manufacturer. Just because the accessory
can be connected to the electric
tool does not guarantee safe
operation.
▪ The rated speed of the accessory
must be at least equal to
the maximum speed marked on
power tool. Accessories,
running faster than theirs
Rated speed can be
break and fly away.
▪ The outer diameter and thickness of
the accessory must be within
permissible for your power tool.
Accessories with inappropriate sizes can not
be adequately protected or
controlled.
▪ The size of the discs, the flanges,
the disc pad or any other accessory must fit properly
power tool spindle.
Accessories with holes that do not match
the mounting frame of the power tool will
are unbalanced / vibrate intensely and
can lead to loss of control.
▪ Do not use a damaged accessory.
Check before each use
accessories such as abrasive discs for
breakage and cracks, the pad of
disc for cracks or wear, wire brush for loose or
cracked heifers. If an electric
tool or accessory is dropped,
check for damage or install
harmless accessory. After checking and
installation of a new accessory, position
Advertisement
