Nokia Customer Care
FTM setup for RX troubleshooting
Put PWB on the module jig. Follow the steps below to configure FTM for RF
troubleshooting.
1.
Connect RF test connector to a spectrum by using CA-89RS RF Test
Cable.
2.
Set SW1 to "FTM mode" in Module Jig.
3.
Connect the 6066 mobile terminal to a PC via the Module Jig, and
connect a power supply.
4.
Open CCS Service Software and run RF Tools function.
5.
The FTM dialog box appears.
6.
Set "Connect Phone".
7.
Set "Set FTM ".
8.
Set "RF Mode" to "CDMA800".
9.
Set "Set Channel "to Channel "384".
10.
Set "Set LNA Range" to whatever needed.
Issue 1 11/2006
Figure 9: FTM dialog box
© 2006 Nokia Corporation
RF Description and Troubleshooting
Company Confidential
7088 (RM-219)
Page 13