Hot Key Power ON
This item allows you to set the hot key power on function while the
system is turned off. Default value is [Ctrl-F1].
Onboard FDC Controller
Select [Enabled] if your system has a floppy disk controller (FDC) in-
stalled on the system board and you wish to use it. If you install add-on FDC
or the system has no floppy drive, select [Disabled] in this field. Available
options are [Disabled] and [Enabled]. Default value is [Enabled]
Onboard Serial Port 1/Port 2
This item allows you to select an address and corresponding interrupt
for the first and second serial ports. Available options are [3F8/IRQ4], [2E8/
IRQ3], [3E8/IRQ4], [2F8/IRQ3], [Disabled] and [Auto]. Default value is [3F8/
IRQ4] for Port 1, and [Disabled] for Port 2.
UART Mode Select
This item allows you to select the UART mode. When set to [Normal],
the following four items will have no function. Available options are [IrDA],
[ASKIR] and [Normal]. Default value is [Normal].
Onboard Parallel Port
There is a built-in-parallel port on the onboard Super I/O chipset that
provides Standard, ECP, and EPP features. Available options are [Disabled],
[3BC/IRQ7], [378/IRQ7], and [278/IRQ5]. Default value is [378/IRQ7].
3-21
Award
®
BIOS Setup