Advertisement
AW00158407000
5 Physical Interface
The blaze-101 camera conforms to the GigE Vision standard.
The camera is interfaced to external circuitry via two connectors:
M12 8-pin X-coded female connector (ERNI, 394811)
Used to provide a 1000 Mbit/s Ethernet connection to the camera.
M12 8-pin A-coded female connector (ERNI, 494166)
Used to provide power to the camera.
Fig. 1: Back View of the Camera
For details of the connector pins, see the following drawing and table.
4
5
3
6
2
7
1
8
GigE Connector
Fig. 2: Connector Pin Numbering
Pin Number
GigE Connector
1
Bidirectional Data Pair A+
2
Bidirectional Data Pair A-
3
Bidirectional Data Pair B+
4
Bidirectional Data Pair B-
5
Bidirectional Data Pair D+
6
Bidirectional Data Pair D-
7
Bidirectional Data Pair C-
8
Bidirectional Data Pair C+
Always connect both Power VCC and Power GND pins.
Basler blaze-101
M12 8-pin X-coded
connector (Ethernet)
Status
LEDs
M12 8-pin A-coded
connector (power)
5
4
6
7
3
2
1
8
Power Connector
Power Connector
Camera Power VCC
Camera Power Ground
Camera Power Ground
Reserved, do not connect
Reserved, do not connect
Reserved, do not connect
Camera Power VCC
Reserved, do not connect
Basler blaze-101 Getting Started Guide
8
Dimensions in mm
Fig. 3: Front, Top, and Side Views of Camera Housing Showing Laser Aperture
and Laser Beam Angle
6 Power Requirements
Power Requirements
24 VDC (± 10 %)
Voltage outside of the specified range can damage the camera.
If you are supplying camera power via the camera's power
connector and the voltage of the power is greater than 24 VDC
(± 10 %), the camera may get damaged. If the voltage is lower than
that, the camera may not work as expected and you may not be able
to acquire images.
7 Installing and Operating the Camera
To operate the camera, Basler recommends downloading the Basler
blaze SDK free of charge from the Basler website:
www.baslerweb.com/blaze
The software package includes necessary drivers and useful tools for
operating the camera as well as sample code.
Also included is the readme.pdf document which contains information
about the installation and the feature scope of the camera.
For information about installing and using the blaze-101 camera, refer
to the Basler Product Documentation available at
docs.baslerweb.com.
Coordinate System of the Camera
The origin of the coordinate system is in the optical center
inside the camera. This creates an offset from the front of
the camera housing that needs to be taken into account
when you're processing the resulting depth data. For more
information, refer to the Basler Product Documentation.
75 °
Power Consumption
<22 W mean @ 24 VDC
<55 W peak @ 24 VDC
NOTICE
3
Advertisement
