Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for INQUA Profi BR021100
Summary of Contents for INQUA Profi BR021100
- Page 1 ® INQUA Profi Vernebler ©2009, AE1000C Vers. 01/09...
-
Page 3: Table Of Contents
® INQUA Profi nebuliser Instructions for use TABLE OF CONTENTS GENERAL_________________________________________________ 22 Manufacturer's data Notes on the instructions for use PRODUCT DESCRIPTION ____________________________________ 23 Components Special notes Correct use Conformity SAFETY INSTRUCTIONS ____________________________________ 26 Representation of hazard warnings Product safety... -
Page 4: General
Notes on the instructions for use Purpose of the instructions for use ® These instructions for use describe how the INQUA Profi nebuliser is as- sembled, how it works, and how it should be used. They are intended to en- sure that the individual components can be used in complete safety. -
Page 5: Product Description
PRODUCT DESCRIPTION Components front Nebuliser upper section Child mask Mouthpiece Air filter for the compressor ® manufactured by INQUA Nebuliser lower section Connection tubing Removal tool for changing the filter Adult mask... -
Page 6: Special Notes
Special notes Note that the nebuliser upper section ( ) and the nebuliser lower section ( ) are attached to each other by a "bayonet" closure. The nebuliser upper sec- tion is inserted carefully into the nebuliser lower section. Pay particular attention to the indication front in the drawing. -
Page 7: Correct Use
Correct use ® Together with the compressor being used, the INQUA Profi nebuliser forms a highly effective inhalation device for treatment of the upper and lower res- piratory tracts with nebulised medication. It is suitable for temporary oral or nasal inhalation of liquid medication prescribed or recommended by a doctor. -
Page 8: Safety Instructions
Indicates a hazard that may cause serious injury or death if it is not avoided. Product safety INQUA GmbH cannot be held responsible for damage that is caused by improper or incorrect use, e.g., use of a compressor made by another manufacturer. Therefore, you are advised to read the instructions for use ®... -
Page 9: Application
Please use only accessories and spare parts that are recommended by INQUA in order to obtain the best possible treatment (see "Spare parts/ Accessories", page 38). It is most important to follow the instructions in chapter "Hygienic re-use", page 32. - Page 10 CAUTION: Inadequate medication nebulising due to incorrect assembly Before inhaling, ensure that all parts are firmly connected to each other. Make sure that the tubing connections are fitted securely to ® the air outlet (AIR) on the INQUA compressor and to the nebuliser.
-
Page 11: Performing The Inhalation
Performing the inhalation WARNING: Danger to health from improper use Contains small parts which can be swallowed! Please note that babies, infants and anyone who requires assistance must be supervised constantly during the inhalation treatment. CAUTION: Inadequate delivery of medication because nebuliser held incorrectly Always hold the nebuliser upright during inhalation. - Page 12 Breathe in as gently as possible through the mouthpiece. After a few seconds, breathe out through your nose.
-
Page 13: Completing The Inhalation
Inhalation is complete when no more aerosol is produced by the nebuliser, or the aerosol only emerges from the nebuliser intermittently. ® When the inhalation session has ended, turn the INQUA compressor off at the On/Off switch. Pull the power plug of the power cord out of the socket (see instructions ®... -
Page 14: Hygienic Re-Use
You should replace the nebuliser at least once a year. Replacement sets can be obtained from your sales partner or from INQUA GmbH (see "Spare parts/ Accessories", page 38). ®... -
Page 15: Preparation For Cleaning/Disinfection
Preparation for cleaning/disinfection ® Directly after each treatment, all parts of the INQUA Profi nebuliser must be cleaned of medication residue and contamination. If this has not been done, disconnect the connection tubing from the ® INQUA Profi nebuliser. Dismantle the nebuliser into its indi-... -
Page 16: Cleaning With Warm Tap Water
DI 6.00 disinfector. Possible alternative: Disinfection with boiling water ® Place the individual parts of your INQUA Profi nebuliser in boiling water for at least 15 minutes. When boiling, make sure that there is enough water in the pot to prevent the nebuliser parts from coming into contact with the base of the pot. -
Page 17: Drying
(e.g., a tea-towel) and keep it in a dry, dust-free environment. Or pack the nebuliser or its individual ® parts in the storage compartment on the INQUA compressor. WARNING: Danger to health from choking or misuse... -
Page 18: Care Of The Connection Tubing
After inhalation, check the connection tubing (4) for condensation. To do this, after each treatment pull the tubing off of the nebuliser and allow the ® INQUA compressor to continue running until all moisture has been re- moved by the airstream. -
Page 19: Miscellaneous
MISCELLANEOUS Storage and transportation conditions ® Do not store the INQUA Profi nebuliser in damp rooms (e.g., bathroom). Do not store or transport it together with damp objects. ® Protect the INQUA Profi nebuliser from continuous, direct sunlight while it is being stored and moved. -
Page 20: Spare Parts/Accessories
SPARE PARTS/ACCESSORIES Item description Item no. ® INQUA Profi nebuliser set BR021100 ® Contents: INQUA Profi nebuliser with mouthpiece, child mask, air filter, adult mask, connection tubing, removal tool for changing the filter TECHNICAL DATA General Recommended nebuliser gases: Minimum flow: 3.0l/min... -
Page 21: Aerosol Characteristics In Accordance With En 13544-1
Profi nebuliser with 3ml of a 2.5% test solution and then ® attach the INQUA Profi nebuliser to a Marple cascade impactor and run for 3 minutes. ® Cumulative mass distribution for the INQUA Profi nebuliser at the minimum flow (3.0l/min) and the maximum flow (6.0l/min): 6l/min 3l/min MMAD [µm]... - Page 22 Determination of the aerosol output rate Fill the nebuliser with 2ml of a 1% test solution. Attach the nebuliser to the PARI Compass Breath Simulator for at least 1 minute. Aerosol output rate in [ml/min] for minimum flow (3.0l/min) and maximum flow (6.0l/min): Min.
- Page 24 82229 Seefeld • Germany Tel.: +49-(0)8152-993410 • Fax: +49-(0)8152-993420 E-Mail: info@inqua.de • www.inqua.de...
Need help?
Do you have a question about the Profi BR021100 and is the answer not in the manual?
Questions and answers