Product Description And Intended Use; Safety Instructions - FIAM. RAY 1701 Product Information

RAY Table
EN
Art. 1701 - 1702 - 1703 - 1704 - 1705 - 1706
Read this information carefully before using the product and keep it for
future reference. Failure to comply carefully with the instructions which
follow may put the safety of the product and its users at risk.

Product description and intended use

1
• Product description and composition
The RAY Table - Art. Code 1701 - 1702 - 1703 - 1704 - 1705 - 1706 is a Table intended as an item of indoor furniture. It is
manufactured from curved float plate glass. The RAY Table was produced at the FIAM ITALIA SPA factory at Via Ancona 1/B, 61010
Tavullia (PU), Italy - Tel: +39.0721.20051 - Fax: +39.0721.202432 - www.fiamitalia.it
• Intended use
The article known as RAY is designed and built to serve as a Table for indoor use and must therefore be used only for this purpose
and no other.
For more information about the product's intended use please refer to section "2) SAFETY INSTRUCTIONS".

Safety instructions

2
To ensure that our product is used in the conditions of the utmost safety, we urge you to comply with the safety instructions
provided below. If in doubt or if you require further information concerning the use of the product, please contact us on the
telephone numbers stated in this document.
• Transporting and storing the RAY Table in the original packaging
The RAY Table, in its original packaging (2 packs; one for the legs and one for the top), must be transported taking the greatest
care to prevent knocks and shaking. It must be stored indoors in a dry place.
Place the RAY Table in the original packaging, in the horizontal position. The arrows on the label on the packaging must be vertical
and pointing upward.
Never place weights or loads in excess of 150 Kg on the original packaging, since exceeding this weight may cause the breakage
of the article.
The RAY Table in the original packaging weighs min 120 kg to max 170 kg.
It must therefore be placed on surfaces capable of supporting its weight.
• Removing the packaging - assembly
To remove the original packaging of the RAY Table, proceed as follows.
a) Place the packaging crate horizontal. The arrows on the labels on the outside must be vertical and pointing upward.
b) Open the packaging crate and remove the sheets of polystyrene. Do not use hammers, saws, cutters or other tools which may
damage the RAY Table.
c) Remove the RAY Table's legs and top from their packaging. In this operation at least two people are required for the legs and
four for the top. Wear gloves which assure a good grip on the float glass.
d) Hold the top horizontally as close to the final position as possible, while two people set the legs close to the aluminum fittings.
Lay the top on the legs, the fittings shall match, tighten the eight screws by means of the proper screw driver.