Table of Contents
Advertisement
Power Management
The Power Management menu lets you configure the system power-
management feature.
The following screen shows the Power Management parameters and their
default settings:
Power Management Mode .......... [Enabled ]
IDE Hard Disk Standby Timer .. [OFF]
System Sleep Timer ........... [OFF] Minute(s)
Sleep Mode
Power Switch < 4 Sec. ........... [Power Off]
**ACPI BIOS Support
System Wake-Up Event
Modem Ring Indicator .......... [Enabled]
↑↓ = Move Highlight Bar
Esc = Exit
NOTE **: Can only be seen when press
Power Management Mode
This parameter allows you to reduce power consumption. When this parameter
is set to Enabled, you can configure the IDE hard disk and system timers.
Setting it to Disabled deactivates the power-management feature and its
timers.
IDE Hard Disk Standby Timer
This parameter allows the hard disk to enter standby mode after inactivity of 1 to
15 minutes, depending on your setting. When you access the hard disk again,
allow 3 to 5 seconds (depending on the hard disk) for the disk to return to
normal speed. Set this parameter to Off if your hard disk does not support this
function.
System Sleep Timer
This parameter automatically puts the system to power-saving mode after a
specified period of inactivity. Any keyboard or mouse action, or any activity
detected from the IRQ channels resumes system operation.
Chapter 2
Power Management
................ [-------]
,
[Enabled]
4
F1 = Help
→ ← = Change Setting,
+
.
Page 1/1
35
Advertisement
Table of Contents
