Advertisement
Available languages
Available languages
1)
Select suitable location for luminaire.
2)
Remove bracket from luminaire, mark wall with appropriate fixing positions. Before drilling, ensure that the hole
does not impinge on pipe work, cables or other building services.
3)
Mount bracket on wall and re-attach luminaire.
4)
The luminaire is supplied with 0.75m of H07RN-F 3G1.5mm² rubber cable.
5)
This product has no user serviceable parts. If any part is damaged, disconnect from mains and discontinue
use.
Remark: The fitting do not provide "assembly screws" please use the properly screw to install the product.
4. Information for the product user
1)
Please note the requirement to dispose of Waste Electrical & Electronic Equipment separately from household
waste (WEEE marked with crossed out wheelie bin symbol).
2)
Please consider your role in contributing to re-use and recycling by returning this product at end of life to a
collection center for waste electrical equipment or a Civic Amenity site, or to a retail outlet from which you are
purchasing a replacement.
3)
This equipment may contain substances that are hazardous to health and the environment if disposed of
carelessly. It is important that it is separated from normal household waste and recycled in the WEEE chain.
4)
The "crossed out wheelie bin symbol" on a product indicates this equipment must not be disposed of in normal
household waste, but should be disposed of according to local WEEE regulations.
5)
If the external flexible cable or cord is damaged, it shall be replaced by the manufacturer agreed service points
or qualified electricians.
6)
Please note that the product is mounted on the wall, and kept with no vibrating during normal use.
The products were IP65 for protection against ingress of dust, solid objects and moisture, the means for connecting
to supply shall have same or higher degree of protection.
5. Installation diagram
Figure 1
Figure 2
3
Advertisement
