Table of Contents
Advertisement
1-5: DVD PCB/DVD DECK (Refer to Fig. 1-5)
1.
Make the short circuit on the position as shown Fig. 1-5
using a soldering. If you remove the DVD Deck with no
soldering, the Laser may be damaged.
Unlock the 2 supports 1.
2.
3.
Remove the Front Tray Plate in the direction of arrow (A).
4.
Disconnect the following connectors:
(CP2001, CP2301 and CP2302).
Remove the 4 screws 2.
5.
6.
Remove the DVD Deck in the direction of arrow (B).
Remove the 4 screws 3.
7.
8.
Remove the DVD PCB in the direction of arrow (C).
Front Tray Plate
1
1
2
(A)
2
DVD Deck
3
3
DVD PCB
NOTE
When the installation of the DVD Deck, remove all the
soldering on the short circuit position after the connection of
Pick Up PCB and DVD PCB connector.
DISASSEMBLY INSTRUCTIONS
Make the short circuit
using a soldering.
2
2
Pick Up PCB
(B)
3
3
(C)
Deck Angle
Fig. 1-5
B1-2
Advertisement
Table of Contents
