Specifications - Dolmar HT-43 Owner's And Safety Manual

ENGLISH (Original instructions)
1-1. Switch trigger B
1-2. Switch trigger A
1-3. Switch trigger C
4-1. Hook complete
4-2. Tool's cord
4-3. Extension cord
5-1. Holder
5-2. Cord

SPECIFICATIONS

Strokes per minute (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbol
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
Do not expose to rain.
･
Remove
immediately if the cable is damaged or
cut.
･
Only for EU countries
Do not dispose of electric equipment
together
material!
In observance of European Directive
2012/19/EU on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is intended for trimming hedges.
Explanation of general view
6-1. Holder
6-2. Arm cord hook band
10-1. Trimming direction
10-2. Tilt the blades
10-3. Hedge surface to be trimmed
11-1. String
15-1. Press
15-2. Chip receiver
Model
Blade length
-1
)
Overall length
Net weight
Safety class
plug from the
with household
equipment and
environmentally compatible
HT-43
420 mm
1,600
821 mm
2.9 kg
END220-5
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical
according to EN60745:
mains
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 2.1 dB(A)
waste
Vibration
The vibration
its
determined according to EN60745:
Work mode : hedge trimming
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
ENE014-1
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
4
15-3. Nut
15-4. Shear blade
16-1. Hooks
16-2. Fit the hooks into groove
16-3. Grooves
17-1. Press the levers on both sides
17-2. Unlock the hooks
HT-49
480 mm
1,600
871 mm
3.0 kg
/II
A-weighted noise level
) : 82 dB(A)
pA
) : 93 dB(A)
WA
Wear ear protection
total value (tri-axial
2
) : 6.7 m/s
h
2
HT-53
520 mm
1,600
921 mm
3.0 kg
ENF002-2
ENG905-1
determined
ENG900-1
vector sum)
ENG901-1