Table of Contents
Advertisement
INSTALLATION
12
Disassembly Instructions
Front grille
1
To remove the front grille, pull out the bottom of
the front grille and then lift up.
Re-install the component by referring to the
removal procedure.
To reinstall the front grille, place the tabs over
2
the top of the unit and push the bottom of front
grille until the clips snap into place.
Angle of discharge grille louvers
• This Room Air Conditioner (PTAC) discharges air
from the top of the unit through reversible, 2-
position discharge grille louvers. The unit is
shipped from the factory with the discharge grille
louvers at an angle of 40° off vertical. In an
alternate position the louvers will be at an angle of
15° off vertical.
40˚
15˚
• To adjust the air direction, remove the front
grille. Remove the 4 screws that fasten the
discharge grille to the front grille. Rotate the
discharge grille 180°, then assembly the
discharge grille to the front grille with 4 screws.
!
WARNING
• Before the following disassembly, POWER
SWITCH is set to OFF and disconnected
the power cord.
Electrical Data
Power cord may include a current interrupter device.
TEST and RESET buttons are provided on the plug
case. The device should be tested on a periodic
basis by first pressing the TEST button and then the
RESET button. If the TEST button does not trip or if
the RESET button will not stay engaged, discontinue
use of the air conditioner and contact a qualified
service technician.
208/230V~
NOTICE
The shape may be different according to its model.
Screws
Advertisement
Table of Contents
