Celestron MICRODIRECT 44316 Instruction Manual page 5

3. USING YOUR MICROSCOPE
A. CONNECT TO A MONITOR OR PROJECTOR
Plug one end of the included HDMI cable into the microscope's Mini (Type C)
+
HDMI port and the other end into your monitor's standard (Type A) HDMI port.
Plug the USB cable into the microscope and then into an open USB 2.0 port
+
on your monitor or projector (if available).
If there is no USB 2.0 port on the monitor or projector, use any 5V-1A USB
+
plug and plug the USB cable into it, and then into an available power outlet.
DO NOT plug the USB cable directly into a desktop or laptop computer as it
will misread the signal from the cable as a storage device and cause a blank
blue screen to appear on the monitor screen.
NOTE: The included USB cable works with all standard USB plugs that come
with many of today's electronics such as smartphones and tablets.
NOTE: An additional option for power is an external power source such as a
power bank that has a standard USB OUT port. All Celestron Elements
hand warmers and power banks will work for this purpose. You can
find them at celestron.com
Power up the microscope by pressing the ON/OFF button (5).
+
B. TAKE A STILL IMAGE
A
Insert your Micro-SD card in the Micro SD card slot (3) on
+
the MicroDirect body.
NOTE: Micro SD Card NOT included.
NOTE: SD Card slot supports up to 32G SDHC.
C
Press the Shutter Trigger button (8) and the captured image
+
will be saved in the Micro-SD card.
B
Loosen the Lock Wheel (15) adjust the course focus by
+
rotating the Course Focus wheel (16).
Tighten the Lock wheel (15) to hold the assembly in place.
+
Turn the Fine Focus wheel (11) to focus on the specimen.
+
5
ENGLISH I