Kenwood KRK-18H Service Manual page 4

2.1.4 Install the KRK-19B onto the NX-3720, NX-3820 RF
Deck
(1) Insert the flat cable into the interface unit (XC3-064M-00)
connector of the KRK-19B. (Fig.2)
KRK-19B KRK-19B KRK-19B
Connector Connector Connector
Note:
The blue line of the flat cable and the flap of connector are
as same side.
After inserting, the flat cable should be locked with the
connector (flap) surely.
(2) Fit the KRK-19B with four tabs onto the front of the chassis.
(Fig.3)
Note:
When installing the KRK-19B onto the front of the chassis,
hold down the flat cable with your fingers to prevent it from
being caught.
2.1.5 Install the KRK-18H onto the NX-3720 or NX-3820
operation panel
(1) Insert the flat cable attached to the interface unit (XC3-
063M-00) of the KRK-18H into the display unit connector of
the panel. (Fig.4)
(The cable has been pre-inserted in the connector of the
KRK-18H.)
Operation panel Operation panel Operation panel
Connector Connector Connector
1-4 (No.RA062<Rev.001>)
RF DECK RF DECK
Fig.2
Fig.3
KRK-18H KRK-18H KRK-18H
Fig.4
Note:
The blue line of the flat cable and the flap of connector are
as same side.
After inserting, the flat cable should be locked with the
connector (flap) surely.
2.1.6 Connect the KRK-19B and KRK-18H with the KCT-71
(1) Insert one lead wire with connector of the KCT-71 into the
connector of the KRK-19B. (Fig.5)
KRK-19B KRK-19B KRK-19B
KCT-71 lead wire KCT-71 lead wire
With connector With connector
(2) Secure the cable bush as shown in the figure 6 and attach
the waterproof packing.
Note:
There is a direction to the installing of the cable bush.
Waterproof Waterproof
Packing Packing
Cable Bush Cable Bush
(3) Slide the molding cover so as not to float the waterproof
packing and attach so that it is locked. (Fig.7)
Molding Cover Molding Cover
(4) Insert the other lead wire with connector of the KCT-71 into
the connector of the KRK-18H.
(5) Attach the waterproof packing and molding cover in the
same way of step 2 and 3.
Fig.5
Fig.6
Fig.7