Disassembly - Kenwood KRK-18H Service Manual

3.1 Precautions for Disassembly
3.1.1 How to remove the KRK-18H rear panel
Insert and remove the flat-head screwdriver as shown in the figure.
3.1.2 Remove the top cover from the shield cover (KRK-18H only)
(1) There are three shield covers on the interface unit, the top covers can be removed.
(2) Use tweezers to slightly lift the edge of the top cover. <1>
<1> <1> <1>
(3) As you do step 2 above, vary the position you hold the top
cover as you lift it, and remove the top cover <2>.
Note:
Once the top cover is removed, it cannot be used again.
<2> <2> <2>
SECTION 3

DISASSEMBLY

Shield cover Shield cover
Insert the screwdriver within this range.
Shield cover (with sheet) Shield cover (with sheet)
Note:
Push evenly on the top cover and be careful that you do not
bend it as you install it on the shield cover.
Note:
How to stick the sheet on the shield cover.
Stick the sheet according to the line as shown in the figure.
(No.RA062<Rev.001>)1-11