Page 1
WE-EF LEUCHTEN Installation and Maintenance Instructions Wall Luminaire Surface Mounted FLC122 LED FLC142 LED Do not open during installation Surge Protection This product is factory-sealed. This product features built-in surge protection circuitry in compliance with Refer to the instructions contained in this applicable standards.
Page 2
Wall Luminaire Surface Mounted FLC122 FLC142 IP55, IK07, Class I, ta= 40°C...
Light Source Maintenance Apart from cleaning the product’s exterior surfaces, no special maintenance work is required. Do not use high-pressure cleaners. In case of component failure due to abnormal circumstances or at end of life, replacement must be carried out by a suitably quali ed and trained professional.
Installation The product must be installed and maintained by a suitably quali ed professional in compliance with latest building/construction and/or electrical regulations and relevant legislation. Warning: Switch off mains electrical supply prior to installing and connecting the luminaire. Notice: If the luminaire is modi ed by anybody other than the original manufacturer, then the warranty will no longer be valid and shall become the full respon- sibility of the modifying person/organisation.
Installation Procedure 1) Switch off mains electrical supply. 2) Remove mounting ange A by loosening screws B. Detach terminal connector C. 3) Check that rating shown on luminaire label 4) Determine position for xing screws D. Drill conforms with mains electrical supply. relevant holes E and insert nylon plugs F.
Page 6
5) Feed mains supply cable G (and second cable 6) To x mounting ange A, pierce through nylon H for through wiring, if required) through plugs J by inserting and tightening screws D. membrane spout(s) I, while setting mounting Attention: Nylon plugs J must remain in ange A in position.