Advertisement
5) Feed mains supply cable G (and second cable
H for through wiring, if required) through
membrane spout(s) I, while setting mounting
ange A in position.
7) Connect mains supply cable G leads to
respective terminals in terminal connector K:
a) ON/OFF (L = Phase, N = Neutral,
= Earthing)
b) 1-10 V/DALI (L = Phase, N = Neutral,
= Earthing, DA/DA = DALI control line,
D–/D+ = 1-10 V control line).
6) To x mounting ange A, pierce through nylon
plugs J by inserting and tightening screws D.
Attention: Nylon plugs J must remain in
position to provide sealing.
8) Ensure that all surfaces are clean and dry.
Position luminaire over mounting ange A
and attach terminal connector C. Tighten
screws B.
5
Advertisement
