English
The stop switch (1) is in the normal run position I.
► Press the manual fuel pump bulb at least five
times – even if the bulb is filled with fuel.
Cold engine (cold start)
2
► Depress the outer ring (arrows) of the choke
knob (2) and then turn it to g .
Warm engine (warm start)
2
► Depress the outer ring (arrows) of the choke
knob (2) and then turn it to f.
12
Also use this setting if the engine has been run‐
ning but is still cold.
1
7.1
► Place the machine on the ground.
► Remove the blade scabbard. Check that the
► Make sure you have a safe and secure foot‐
► Hold the machine firmly with your left hand on
► Hold the starter grip with your right hand.
7.1.1
► Pull the starter grip slowly until you feel it
NOTICE
Do not pull out the starter rope all the way – it
might otherwise break.
► Do not let the starter grip snap back. Guide it
7.1.2
► Pull the starter grip steadily.
7.2
7 Starting / Stopping the Engine
Cranking
cutting blades are not touching the ground or
any other obstacles.
ing.
the fan housing and press down.
Version without ErgoStart
engage and then give it a brisk strong pull.
slowly back into the housing so that the starter
rope can rewind properly.
Version with ErgoStart
As Soon As the Engine Runs
0458-448-8321-C